Husqvarna 7021CM HOW to USE Your Lawn Mower, Engine Speed, Engine Zone Control, To Convert Mower

Page 6

OPERATION

The operation of any lawn mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your lawn mower or per- forming any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask over spectacles.

HOW TO USE YOUR LAWN MOWER

ENGINE SPEED

The engine speed was set at the factory for optimum per- formance. Speed is not adjustable.

ENGINE ZONE CONTROL

CAUTION: Federal regulations require an engine control to be installed on this lawn mower in order to minimize the risk of blade contact injury. Do not under any circumstances attempt to defeat the function of the operator control. The blade turns when the engine is running.

Your lawn mower is equipped with an operator presence control bar which requires the operator to be positioned behind the lawn mower handle to start and operate the lawn mower.

TO ADJUST CUTTING HEIGHT (See Fig. 3)

Raise wheels for low cut and lower wheels for high cut, adjust cutting height to suit your requirements. Medium position is best for most lawns.

To change cutting height, squeeze adjuster lever toward wheel.Move wheel up or down to suit your requirements. Be sure all wheels are in the same setting.

NOTE:Adjuster is properly positioned when plate tab inserts into hole in lever. Also, 9-position adjusters (if so equipped) allow lever to be positioned between the plate tabs.

LEVER BACKWARD TO LOWER MOWER

PLATE

TAB

LEVER FORWARD TO RAISE MOWER

LEVER

FIG. 3

TO CONVERT MOWER

Your lawn mower was shipped ready to be used as a mulcher. To convert to bagging or discharging:

REAR BAGGING (See Fig. 4)

Lift rear door of the lawn mower and place the grass catcher frame hooks onto the door pivot pins.

To convert to mulching or discharging operation, remove grass catcher and close rear door.

PIVOT PINS

REAR

 

DOOR

 

GRASS

 

CATCHER

 

HANDLE

CATCHER FRAME HOOK

 

FIG. 4

SIDE DISCHARGING (See Fig. 5)

Rear door must be closed.

Open mulcher door and install discharge defl ector under door as shown.

Mower is now ready for discharging operation.

To convert to mulching or bagging operation, discharge defl ector must be removed and mulcher door must be closed.

SIMPLE STEPS TO REMEMBER

WHEN CONVERTING YOUR LAWN MOWER

FOR MULCHING -

1.Rear door closed.

2.Mulcher door closed.

FOR REAR BAGGING -

1.Grass catcher installed.

2.Mulcher door closed.

FOR SIDE DISCHARGING -

1.Rear door closed.

2.Discharge defl ector installed.

CAUTION: Do not run your lawn mower without rear door closed or approved grass catcher in place. Never attempt to operate the lawn mower with the rear door removed or propped open.

6

Image 6
Contents 7021CM General Operation IV. ServiceSafe Operation Practices for Walk-Behind Mowers III. ChildrenTable of Contents To Install Attachments AssemblyHOW to SET UP Your Lawn Mower To Remove Lawn Mower from CartonMeets Cpsc Safety Requirements OperationKnow Your Lawn Mower Engine Speed HOW to USE Your Lawn MowerTo Adjust Cutting Height See Fig Engine Zone ControlBefore Starting Engine To Empty Grass Catcher See FigADD OIL See Fig To Stop Engine ADD Gasoline See FigMulching Mowing Tips To Start EngineGeneral Recommendations MaintenanceLubrication Chart Before Each USETires Lawn MowerEngine Blade CareAIR Filter See Fig CleaningTo Change Engine OIL See Fig MufflerTo Adjust Handle See Figs thru Service and AdjustmentsTo Adjust Cutting Height Rear DeflectorFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionService Notes Page 532 18 Axle Arm Assembly LR KEY Part DescriptionHusqvarna Service Notes