Husqvarna 7021CP owner manual Storage, Other, Fuel System, Engine OIL, Cylinder

Page 13

STORAGE

Immediately prepare your lawn mower for storage at the end of the season or if the unit will not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire lawn mower (See “CLEANING” in the Maintenance section of this manual).

2.Lubricate as shown in the Maintenance section of this manual.

3.Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

4.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

HANDLE (See Figs. 15 and 16)

You can fold your lawn mower handle for storage.

1.Squeeze the bottom ends of the lower handle toward each other until the lower handle clears the handle bracket, then move handle forward.

2.Loosen upper handle mounting bolts enough to allow upper handle to be folded back.

IMPORTANT: WHEN FOLDING THE HANDLE FOR STORAGE OR TRANSPORTATION, BE SURE TO FOLD THE HANDLE AS SHOWN OR YOU MAY DAMAGE THE CONTROL CABLES.

Whensettingupyourhandlefromthestorageposition,the lower handle will automatically lock into mowing position.

SQUEEZE

TO ADJUST

LOWER HANDLE

FIG. 15

OPERATOR

MOWING

POSITION

PRESENCE

CONTROL

 

BAR

 

FOLD

FORWARD

FOR

STORAGE

UPPER

HANDLE

HANDLE

KNOB

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANTTO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Empty the fuel tank by starting the engine and letting it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER

1.Remove spark plug.

2.Pour one ounce (29 ml) of oil through spark plug hole into cylinder.

3.Pull starter handle slowly a few times to distribute oil.

4.Replace with new spark plug.

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your unit indoors and cover it to give protection from dust and dirt.

Cover your unit with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe, which allows condensation to form and will cause your unit to rust.

IMPORTANT: NEVER COVER MOWER WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

CAUTION: Never store the lawn mower with gasoline in the tank inside a build- ing where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

LOWER HANDLE

FIG. 16

13

Image 13
Contents 7021CP II. Slope Operation Safe Operation Practices for Walk-Behind MowersGeneral Operation III. ChildrenTable of Contents HOW to SET UP Your Lawn Mower AssemblyTo Install Attachments To Remove Lawn Mower from CartonOperation Meets Cpsc Safety RequirementsKnow Your Lawn Mower To Adjust Cutting Height See Fig HOW to USE Your Lawn MowerEngine Speed Engine Zone ControlTo Empty Grass Catcher See Fig Before Starting EngineADD OIL See Fig To Stop Engine ADD Gasoline See FigTo Start Engine Mowing TipsLubrication Chart MaintenanceGeneral Recommendations Before Each USEEngine Lawn MowerTires Blade CareTo Change Engine OIL See Fig CleaningAIR Filter See Fig MufflerTo Adjust Cutting Height Service and AdjustmentsTo Adjust Handle See Figs thru Rear DeflectorOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsService Notes Page KEY Part Description Husqvarna

7021CP specifications

The Husqvarna 7021CP is a well-crafted lawn mower that stands out among its peers with an impressive combination of performance, durability, and user-friendly design. Perfectly suited for homeowners with medium to large yards, this push mower effectively handles various grass conditions thanks to its powerful engine and intelligent engineering.

At the heart of the Husqvarna 7021CP is a robust 160cc Honda GCV engine, known for its reliability and efficiency. This dependable engine allows for smooth operation and consistent cutting performance, ensuring that mowing is not only efficient but also less strenuous. The mower features a 21-inch cutting deck, constructed from high-quality steel to provide longevity and resistance against wear and tear. This size strikes an excellent balance, allowing for maneuverability in tighter spaces while still covering more ground quickly.

One of the standout features of the 7021CP is its adjustable cutting height. The mower offers six different cutting positions ranging from 1 to 4 inches, giving users the flexibility to choose the perfect length for their grass. This feature is crucial for maintaining a healthy lawn, allowing for optimal grass health and appearance.

The Husqvarna 7021CP incorporates a dual function of mulching and bagging. The mulching feature finely chops grass clippings and returns them to the lawn, providing essential nutrients and moisture back to the soil. For those who prefer a cleaner finish, the rear bagging option neatly collects clippings for easy disposal. Changing between the two modes is straightforward, enhancing convenience during mowing.

In terms of user comfort, the 7021CP is designed with ergonomics in mind. It features a comfortable handle with an adjustable height, ensuring that users of varying statures can find a suitable grip. The lightweight design further simplifies maneuvering, making it ideal for longer mowing sessions.

The mower also boasts easy-start technology, ensuring that users can quickly get to work without the frustrations often associated with starting gas mowers. Coupled with its sturdy wheels, typically larger in the back for enhanced traction, the Husqvarna 7021CP allows for smooth navigation across different terrains.

Overall, the Husqvarna 7021CP is a reliable, efficient, and user-friendly lawn mower, equipped with the necessary features to meet the demands of modern homeowners. With its robust engine, adjustable cutting height, and dual-function capabilities, it is a valuable addition to any lawn care toolkit.