Husqvarna 62522FE HOW to USE Your Lawn Mower, Engine Speed, Engine Zone Control, To Convert Mower

Page 6

OPERATION

The operation of any lawn mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your lawn mower or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask over spectacles.

HOW TO USE YOUR LAWN MOWER

ENGINE SPEED

The engine speed was set at the factory for optimum per- formance. Speed is not adjustable.

ENGINE ZONE CONTROL

CAUTION: Federal regulations require an engine control to be installed on this lawn mower in order to minimize the risk of blade contact injury. Do not under any circumstances attempt to defeat the function of the operator control. The blade turns when the engine is running.

Your lawn mower is equipped with an operator pres- ence control bar which requires the operator to be positioned behind the mower handle to start and operate the mower.

TO OPERATE DRIVE SYSTEM (See Fig. 4)

To start forward motion, lift drive control bar up to handle.

To stop forward motion, release drive control bar.

IMPORTANT: ALWAYS KEEP DRIVE CONTROL FULLY ENGAGED AGAINST HANDLE WHEN IN USE.

TO ADJUST CUTTING HEIGHT (See Fig. 5)

Raise wheels for low cut and lower wheels for high cut, adjust cutting height to suit your requirements. Medium position is best for most lawns.

To change cutting height, squeeze adjuster lever toward wheel. Move wheel up or down to suit your require- ments. Be sure all wheels are in the same setting.

NOTE:Adjusterisproperlypositionedwhenplatetabinserts into hole in lever. Also, 9-position adjusters (if so equipped) allow lever to be positioned between the plate tabs.

LEVER BACKWARD TO LOWER MOWER

 

PLATE

 

TAB

 

LEVER FORWARD TO RAISE MOWER

LEVER

 

FIG. 5

TO ENGAGE DRIVE CONTROL

OPERATOR

PRESENCE

CONTROL BAR

DRIVE CONTROL DISENGAGED

FIG. 4

TO CONVERT MOWER

Your lawn mower was shipped ready to be used as a mulcher. To convert to bagging or discharging:

REAR BAGGING (See Fig. 6)

Open rear door and remove mulcher plug. Store mulcher plug in a safe place.

You can now install the grass catcher or optional clip- ping deflector.

To convert to mulching or discharging operation, install mulcher plug into rear discharge opening of mower.

MULCHER

PLUG

FIG. 6

6

Image 6
Contents 62522FE General Operation Safe Operation Practices for Walk-Behind MowersII. Slope Operation III. ChildrenTable of Contents To Prepare Battery See Fig AssemblyTo Install Attachments To Remove Lawn Mower from CartonMeets Cpsc Safety Requirements OperationKnow Your Lawn Mower Engine Zone Control HOW to USE Your Lawn MowerEngine Speed To Convert MowerTo Empty Grass Catcher See Fig Simple Steps to Remember When Converting Your Lawn MowerBefore Starting Engine ADD OIL See FigTo Start Engine ADD Gasoline See FigTo Stop Engine Mowing TipsGeneral Recommendations MaintenanceLubrication Chart Before Each USELawn Mower Engine CleaningClean Under Drive Cover MufflerService and Adjustments To Adjust Cutting HeightRear Deflector Storage CarburetorFuel System BatteryOther Engine OILTroubleshooting Points Problem Cause CorrectionPage KEY Part Description Page KEY Part Description Limited Warranty Husqvarna S Obligations Under the Warranty