Husqvarna 6022CH owner manual Troubleshooting Points, Problem Cause Correction

TROUBLESHOOTING POINTS

PROBLEM	CAUSE			CORRECTION
Does not start	1.	Dirty air filter.	1.	Clean/replace air filter.
	2.	Out of fuel.	2.	Fill fuel tank.
	3.	Stale fuel.	3.	Drain tank and refill with
				fresh clean fuel.
	4.	Water in fuel.	4.	Drain fuel tank and
				carburetor and refill tank
				with fresh gasoline.
	5.	Spark plug wire is	5.	Connect wire to plug.
		disconnected.
	6.	Bad spark plug.	6.	Replace spark plug.
	7.	Loose blade or broken	7.	Tighten blade bolt or
		blade adapter.		replace blade adapter.
	8.	Control bar in released	8.	Depress control bar to
		position.		handle.
	9.	Control bar defective.	9.	Replace control bar.
Loss of power	1.	Rear of lawn mower	1.	Set to “Higher Cut”
		housingor cutting blade		position.
		dragging in heavy grass.
	2.	Cutting too much grass.	2.	Set to “Higher Cut”
		position.
	3.	Dirty air filter.	3.	Clean/replace air filter.
	4.	Buildup of grass, leaves,	4.	Clean underside of mower
		and trash under mower.		housing.
	5.	Too much oil in engine.	5.	Check oil level.
	6.	Walking speed too fast.	6.	Cut at slower walking
				speed.
Poor cut –	1.	Worn, bent or loose blade.	1.	Replace blade. Tighten
uneven				blade bolt.
	2.	Wheel heights uneven.	2.	Set all wheels at same
		height
	3.	Buildup of grass, leaves	3.	Clean underside of
		and trash under mower.		mower housing.
Excessive	1.	Worn, bent or loose blade.	1.	Replace blade. Tighten
vibration				blade bolt.
	2.	Bent engine crankshaft.	2.	Contact a qualified
				service center.
Starter rope hard	1.	Engine flywheel brake is on	1.	Depress control bar to
to pull		when control bar is released.		upper handle before
		pulling starter rope.
	2.	Bent engine crankshaft.	2.	Contact a qualified
				service center.
	3.	Blade adapter broken.	3.	Replace blade adapter.
	4.	Blade dragging in grass.	4.	Move lawn mower to cut
				grass or to hard surface.
Grass catcher	1.	Cutting height too low.	1.	Raise cutting height.
not filling (if so	2.	Lift on blade worn off.	2.	Replace blade.
equipped)	3.	Catcher not venting air.	3.	Clean grass catcher.
Hard to push	1.	Grass is too high or wheel	1.	Raise cutting height.
		height is too low.
	2.	Rear of lawn mower	2.	Raise rear of lawn mower
		housing or blade dragging		housing one (1) setting
		in grass.		higher.
	3.	Grass catcher too full.	3.	Empty grass catcher.
	4.	Handle height position not	4.	Adjust handle height to
		right for you.		suit.

15