HOW to USE Your Lawn Mower, Engine Speed

OPERATION

The operation of any lawn mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your lawn mower or per- forming any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask over spectacles.

HOW TO USE YOUR LAWN MOWER

ENGINE SPEED

The engine speed was set at the factory for optimum per- formance. Speed is not adjustable.

3.Operate mower to test drive speed. Readjust as re- quired.

4.If condition fails to improve after the above steps (for- ward speed remains the same), your drive belt is worn and should be replaced.

ENGINE ZONE CONTROL

CAUTION: Federal regulations require an engine control to be installed on this lawn mower in order to minimize the risk of blade contact injury. Do not under any circumstances attempt to defeat the function of the operator control. The blade turns when the engine is running.

•Your lawn mower is equipped with an operator presence control bar which requires the operator to be positioned behind the mower handle to start and operate the mower.

ADJUSTMENT TURNBUCKLE

FIG. 5

DRIVE CONTROL (See Fig. 4)

•Self-propelling is controlled by holding the operator presence control bar down to the handle and pulling either drive control lever rearward to the handle. The further toward the handle a lever is pulled, the faster the unit will travel.

•Forward motion will stop when either the operator pres- ence control bar or a drive control lever are released. To stop forward motion without stopping engine, release a drive control lever only. Hold operator presence control bar down against handle to continue mowing without self-propelling.

NOTE: If after releasing the drive control the mower will not roll backwards, push the mower forward slightly to disengage drive wheels.

OPERATOR PRESENCE CONTROL BAR
	DRIVE
	CONTROL
	LEVERS
TO ENGAGE	DRIVE CONTROL
DRIVE CONTROL	DISENGAGED

FIG. 4

DRIVE CONTROL ADJUSTMENT (See Fig. 5)

Over time, the drive control system may become “loose”, resulting in decreased speed. There is a turnbuckle on the drive control housing to increase tension on the drive cable. Proceed as follows:

1.Turn unit off, disconnect spark plug wire from plug.

2.Rotate turnbuckle on drive control to increase drive

speed.6

TO ADJUST CUTTING HEIGHT (See Fig. 6)

Raise wheels for low cut and lower wheels for high cut, adjust cutting height to suit your requirements. Medium position is best for most lawns.

•To change cutting height, squeeze adjuster lever toward wheel. Move wheel up or down to suit your requirements. Be sure all wheels are in the same setting.

NOTE: Adjuster is properly positioned when plate tab inserts into hole in lever. Also, 9-position adjusters (if so equipped) allow lever to be positioned between the plate tabs.

ROTATE LEVER TOWARD ENGINE

TO LOWER MOWER

PLATE

TAB

LEVER

ROTATE LEVER AWAY FROM ENGINE TO RAISE MOWER

FIG. 6

TO CONVERT MOWER

Your lawn mower was shipped ready to be used as a mulcher. To convert to bagging:

REAR BAGGING (See Fig. 7)

•Lift rear door of the lawn mower and place the grass catcher frame hooks onto the grass bag brackets.

•To convert to mulching operation, remove grass catcher and close rear door.