Husqvarna 96045001501 Transmission, REPLACING BATTERY See Fig, To Replace Headlight Bulb, Engine

Page 24
REPLACING BATTERY (See Fig. 39)

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Fig. 39)

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift hood to raised position.

•Remove terminal cover.

•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•Reinstall terminal cover.

•First connect RED battery cable to positive (+) battery terminal with bolt and nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) battery terminal with remaining bolt and nut. Tighten securely

•Close hood.

NEGATIVE (BLACK)

CABLE

TERMINAL

COVER TO REPLACE HEADLIGHT BULBINTERLOCKS AND RELAYSTO REPLACE FUSETO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 40)

POSITIVE (RED)

CABLE

Fig. 39

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 40)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

02778

Fig. 40

TRANSMISSION

REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and beforeoperatingthetractor. See“PURGETRANSMISSION” in the Operation section of this manual.

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and adjust- ment should not be necessary. If adjustment is necessary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents LGT2554 03002SAFETY RULES Safe Operation Practices for Ride-On MowersI. GENERAL OPERATION II. SLOPE OPERATIONV. SERVICE III. CHILDRENIV. TOWING TABLE OF CONTENTS PRODUCT SPECIFICATIONSCUSTOMER RESPONSIBILITIES ASSEMBLY TOOLS REQUIRED FOR ASSEMBLYTO CHECK BATTERY See Fig UNASSEMBLED PARTSTO ADJUST SEAT See Fig TO INSTALL MOWER See FigsASSEMBLE FRONT WHEEL TO MOWER See Fig ASSEMBLY CHECK TIRE PRESSURE CHECK DECK LEVELNESSCHECKFORPROPERPOSITIONOFALLBELTS CHECK BRAKE SYSTEMOPERATION KNOW YOUR TRACTOR BQ ACJ MHOW TO USE YOUR TRACTOR TO SET PARKING BRAKESee FigSTOPPING See Fig TO USE THROTTLE CONTROL See FigTO ADJUST GAUGE WHEELS See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO MOVE FORWARD AND BACKWARD See Fig TO OPERATE MOWERSERVICE REMINDER/HOUR METER REVERSE OPERATION SYSTEM ROS See FigTO OPERATE ON HILLS TO TRANSPORT See Fig. 13 andBEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVELADD GASOLINE TO START ENGINE See FigMOWING TIPS PURGE TRANSMISSIONMAINTENANCE MAINTENANCEGENERAL RECOMMENDATIONS SCHEDULEBATTERY TRACTORBLADE CARE BLADE REMOVAL See FigTRANSAXLE MAINTENANCE CLEAN AIR SCREENENGINE TRANSAXLE PUMP FLUIDCLEANING ENGINE COOLING SYSTEMMUFFLER SPARK PLUGSSERVICE AND ADJUSTMENTS TO INSTALL MOWERTO REMOVE MOWER See Fig TO REPLACE MOWER BLADE DRIVE BELT See FigTO LEVEL MOWER TO ADJUST STEERING WHEEL ALIGNMENT TO REPLACE MOTION DRIVE BELT See FigTO CHECK BRAKE FRONT WHEEL TOE-IN/CAMBERTRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT See Fig TO START ENGINE WITH A WEAK BATTERY See FigREPLACING BATTERY See Fig TO REMOVE HOOD AND GRILL ASSEMBLY See FigREMOVAL/REPLACEMENT TO ADJUST THROTTLE CONTROL CABLESTORAGE OTHERFUEL SYSTEM ENGINE OILTROUBLESHOOTING POINTS TROUBLESHOOTING POINTS SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAXWARRANTY STATEMENT SECTION 1 LIMITED WARRANTYSECTION 2 HUSQVARNA’S OBLIGATIONS UNDER THE WARRANTY SECTION 3 ITEMS NOT COVERED BY THIS WARRANTY
Top Page Image Contents