Husqvarna 96045001501, 532 42 89-49 TO ADJUST SEAT See Fig, TO INSTALL MOWER See Figs, Assembly

Page 6
TO ADJUST SEAT (See Fig. 2):

ASSEMBLY

TO ADJUST SEAT (See Fig. 2):

•Grasp adjustment handle(A) and pull up, slide seat to desired position and release adjustment handle.

A

TO INSTALL MOWER (See Figs. 4-12)

Be sure tractor is on level surface and engage parking brake.

•Lower attachment lift lever to it's lowest position.

CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position.

•Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield to the right.

Fig. 2

NOTE: You may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid.

TO INSTALL MOWER (See Figs. 4-12)WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Releaseparkingbrakebydepressingclutch/brakepedal.

•Place freewheel control in "transmission disengaged" position (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

Continue with the instructions that follow.

ASSEMBLE FRONT WHEEL TO MOWER (See Fig. 3)

•Using shoulder bolt, washer and locknut from parts bag, assemble front wheel to mower as shown. Tighten securely.

Fig. 3

02965

Fig. 4

NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor.

•Slide mower under tractor until it is centered under tractor.

A

Fig. 5

•FIRST INSTALL ANTI-SWAY BAR (S).

•From right side of mower, insert anti-sway bar into hole in transmission bracket (T).

 

T

S

 

 

 

A

 

6

 

Fig. 6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents LGT2554 03002I. GENERAL OPERATION SAFETY RULESSafe Operation Practices for Ride-On Mowers II. SLOPE OPERATIONV. SERVICE III. CHILDRENIV. TOWING TABLE OF CONTENTS PRODUCT SPECIFICATIONSCUSTOMER RESPONSIBILITIES TO CHECK BATTERY See Fig ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY UNASSEMBLED PARTSTO ADJUST SEAT See Fig TO INSTALL MOWER See FigsASSEMBLE FRONT WHEEL TO MOWER See Fig ASSEMBLY CHECKFORPROPERPOSITIONOFALLBELTS CHECK TIRE PRESSURECHECK DECK LEVELNESS CHECK BRAKE SYSTEMOPERATION KNOW YOUR TRACTOR BQ ACJ MSTOPPING See Fig HOW TO USE YOUR TRACTORTO SET PARKING BRAKESee Fig TO USE THROTTLE CONTROL See FigTO MOVE FORWARD AND BACKWARD See Fig TO ADJUST GAUGE WHEELS See FigTO ADJUST MOWER CUTTING HEIGHT See Fig TO OPERATE MOWERTO OPERATE ON HILLS SERVICE REMINDER/HOUR METERREVERSE OPERATION SYSTEM ROS See Fig TO TRANSPORT See Fig. 13 andADD GASOLINE BEFORE STARTING THE ENGINECHECK ENGINE OIL LEVEL TO START ENGINE See FigMOWING TIPS PURGE TRANSMISSIONGENERAL RECOMMENDATIONS MAINTENANCEMAINTENANCE SCHEDULEBLADE CARE BATTERYTRACTOR BLADE REMOVAL See FigENGINE TRANSAXLE MAINTENANCECLEAN AIR SCREEN TRANSAXLE PUMP FLUIDMUFFLER CLEANINGENGINE COOLING SYSTEM SPARK PLUGSTO REMOVE MOWER See Fig SERVICE AND ADJUSTMENTSTO INSTALL MOWER TO REPLACE MOWER BLADE DRIVE BELT See FigTO LEVEL MOWER TO CHECK BRAKE TO ADJUST STEERING WHEEL ALIGNMENTTO REPLACE MOTION DRIVE BELT See Fig FRONT WHEEL TOE-IN/CAMBERTRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT See Fig TO START ENGINE WITH A WEAK BATTERY See FigREMOVAL/REPLACEMENT REPLACING BATTERY See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig TO ADJUST THROTTLE CONTROL CABLEFUEL SYSTEM STORAGEOTHER ENGINE OILTROUBLESHOOTING POINTS TROUBLESHOOTING POINTS SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAXSECTION 2 HUSQVARNA’S OBLIGATIONS UNDER THE WARRANTY WARRANTY STATEMENTSECTION 1 LIMITED WARRANTY SECTION 3 ITEMS NOT COVERED BY THIS WARRANTY
Top Page Image Contents