Husqvarna 532 42 89-49 Storage, Other, Fuel System, Engine Oil, Cylinders, Tractor, Battery

Page 25
STORAGE

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thor- oughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

25

Image 25
Contents 03002 LGT2554Safe Operation Practices for Ride-On Mowers SAFETY RULESI. GENERAL OPERATION II. SLOPE OPERATIONIII. CHILDREN V. SERVICEIV. TOWING PRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES TOOLS REQUIRED FOR ASSEMBLY ASSEMBLYTO CHECK BATTERY See Fig UNASSEMBLED PARTSTO INSTALL MOWER See Figs TO ADJUST SEAT See FigASSEMBLE FRONT WHEEL TO MOWER See Fig ASSEMBLY CHECK DECK LEVELNESS CHECK TIRE PRESSURECHECKFORPROPERPOSITIONOFALLBELTS CHECK BRAKE SYSTEMOPERATION BQ ACJ M KNOW YOUR TRACTORTO SET PARKING BRAKESee Fig HOW TO USE YOUR TRACTORSTOPPING See Fig TO USE THROTTLE CONTROL See FigTO ADJUST MOWER CUTTING HEIGHT See Fig TO ADJUST GAUGE WHEELS See FigTO MOVE FORWARD AND BACKWARD See Fig TO OPERATE MOWERREVERSE OPERATION SYSTEM ROS See Fig SERVICE REMINDER/HOUR METERTO OPERATE ON HILLS TO TRANSPORT See Fig. 13 andCHECK ENGINE OIL LEVEL BEFORE STARTING THE ENGINEADD GASOLINE TO START ENGINE See FigPURGE TRANSMISSION MOWING TIPSMAINTENANCE MAINTENANCEGENERAL RECOMMENDATIONS SCHEDULETRACTOR BATTERYBLADE CARE BLADE REMOVAL See FigCLEAN AIR SCREEN TRANSAXLE MAINTENANCEENGINE TRANSAXLE PUMP FLUIDENGINE COOLING SYSTEM CLEANINGMUFFLER SPARK PLUGSTO INSTALL MOWER SERVICE AND ADJUSTMENTSTO REMOVE MOWER See Fig TO REPLACE MOWER BLADE DRIVE BELT See FigTO LEVEL MOWER TO REPLACE MOTION DRIVE BELT See Fig TO ADJUST STEERING WHEEL ALIGNMENTTO CHECK BRAKE FRONT WHEEL TOE-IN/CAMBERTO START ENGINE WITH A WEAK BATTERY See Fig TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig REPLACING BATTERY See FigREMOVAL/REPLACEMENT TO ADJUST THROTTLE CONTROL CABLEOTHER STORAGEFUEL SYSTEM ENGINE OILTROUBLESHOOTING POINTS TROUBLESHOOTING POINTS ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAX SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATIONSECTION 1 LIMITED WARRANTY WARRANTY STATEMENTSECTION 2 HUSQVARNA’S OBLIGATIONS UNDER THE WARRANTY SECTION 3 ITEMS NOT COVERED BY THIS WARRANTY