OPERATION
CAUTION
Attempting to zero turn at too high a ground speed may result inTURF DAMAGE due to the wheel spinning or slipage. The unit should always be brought to a very slow or stopped position prior to zero turning.
Use extra care when using this maneuver the machine can spin very rapidly if one lever is positioned too far ahead of the other.
TO ADJUST THE DECK CUTTING
HEIGHT (See Fig. 5)
The deck cutting height is obtained by pressing the foot pedal forward to lift the deck. To lower the deck, you apply pressure to the top side of the foot pedal and allow it to pivot while allowing the lift arm to rotate to the rear of the mower. To stop in a desired cutting position, rotate the foot pedal down into the notch in the height plate. The cutting height range is from 1 1/2" to 5" in 1/2" increments. The heights are measured from the ground up to the blade tip with the engine not running.
_i_ CAUTION
DO NOT apply excessive force to control
levers or use to assist in dismounting unit. Misuse will result in bent control levers.
The average lawn should be cut to 2 1/2" during the cool season and to over 3" during the hot months. For healthier and better looking lawns, mow often and after moderate growth.
For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to the desired height.
FIGURE 5
FIGURE 4A
15