Husqvarna 968999245/ CZ3815, 968999246/CZ4217 manual Service and Adjustment, Mower, To Level Deck

Page 23

SERVICE AND ADJUSTMENT

Recheck measurements after

adjustment.

FIGURE 11

MOWER

TO LEVEL DECK

Adjust the deck while the mower is on a level surface. Make sure the tires are inflated to the

correct pressure (see "SPECIFICATIONS"

section in this manual). If tires are under or over inflated, you can not properly adjust your deck.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 11 and 12)

Raise the deck into the highest cutting position (4")

Measure height from the bottom edge ofFIGURE 12 the deck to the ground at both front

corners. Distance "A" should be the same, or within 3/16 of an inch.

If adjustment is necessary, make adjustment to one side of the deck only Remove the hairpin from the top pin and the bottom clevis pin. Push bottom clevis pin through deck lift connector while

supporting deck. Adjust by moving the deck lift connector to a new bottom hole

to lower or raise that specific corner of the deck. You may need to flip the deck connector plate to insure proper clearance between deck connector plate and yoke

23

Image 23
Contents Manual no REV. IR 1/14/04 968999245/ CZ3815 968999246/CZ4217Good Service Contents Safe Operation Practices for RIDE-ON Mowers Safety RulesGeneral Operation I1. Slope OperationDo not IV. ServiceII1. Children Never allow children to operate the machine Safe Operation PracticesCustomer Responsibilities SpecificationsUnpack Crate AssemblyTools Required For Assembly To Remove the Mower From CrateTo Drive the Mower OFF To Roll the Mower OFF of the SkidCheck the Tire Pressure Utility BOX InstallationChecklist Controls OperationTo USE Throttle Control See Fig HOW to USE Your MowerBefore Starting the Engine ADD GasolineTo Stop Engine To Start Engine See FigSee Fig To Move Forward and BackwardHeight See Fig To Adjust the Deck CuttingTo Transport See Figures 6 & 6A To Operate on HillsTo Operate Mower Mowing TipsBefore Each USE Maintenance ScheduleGeneral Recommendations Tires Lubrication ChartOperator Presence System Blade CareImportant Special Blade Bolt is Heat Treated To Sharpen Blade See FigBatte RY Lubrication To Clean Batteryand TerminalsBelts EngineSpark Plugs Clean AIR INTAKE/COOLING AreasClean AIR Screen AIR FilterTo Level Deck Service and AdjustmentMower Stay Level Side to Side To Replace Deck BeltPark the mower on a level surface. Engage the park brake Deck Belt Installation See FigsBelt Installation To Replace EZT E-Series Zerotum Transaxle Belt See FigWeak Battery To Remove Wheels for Repair To Adjust the Seat See FigTo Adjust Control Lever To Attach Jumper Cables Replacing Battery See FigTo Adjust Park Brake Tracking Adjustment Engine OIL BatteryStorage Fuel SystemCylinders OtherCause Correction Troubleshooting PointsProblem Problemcause Page Husqvarna