OPERATION
TO OPERATE ON HILLS
The slowest speed possible should be used before starting up or down hills. Avoid stopping or changing speed on hills.
If stopping is absolutely necessary, pull drive levers into the neutral position and push to the outside of the unit and engage the park brake.
To restart movement, release the park brake.
Pull the control levers back to the center of the mower and press forward to regain forward motion.
Make all turns slowly.
TO TRANSPORT (See Figures 6 & 6A)
When pushing or pulling the mower, be sure to engage the EZT
CAUTION
Do not tow this vehicle, it may cause dam-
age to the drive system.
Raise the deck into the highest cutting position.
Pull the EZT bypass linkages out and into the slots and release so that it is held in the bypass position.
To reengage the EZT's to drive, reverse the above procedure.
FIGURE 6
HEAD OUTSIDE
EZT BYPASS
LINKAGE IN
BYPASS POSITION
FIGURE 6A
16