Husqvarna WH3616 / 966638601, WH5218 / 966638603 manual Tire Pressures, Deck Belt, Replacing belt

Page 32

MAINTENANCE

Tire Pressures

All tires should be at 15 psi / 103 kPa / 1 bar.

Deck Belt

Check every 100 hours of operation. Check for severe cracking and large nicks.

NOTE: The belt will show some small cracks in normal operation.

Replacing belt

Open the belt shield.

Use a ratchet with a ½ socket extension on the spring idler arm to relieve the tension on the belt. Slide the belt off the pulley and fully remove the belt.

Reverse the procedure for installation. After installation is complete check the belt for twists.

8062-042

Tire pressures

8062-023

Slacken the belt tensioner

32

Image 32

Contents Operator Manual All rights reserved Contents Page Introduction CongratulationsGeneral Driving and Transport on Public RoadsGood Service Manufacturing NumberSymbols and decals Safety General OperationPersonal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Transport Controls Control LocationsDrive Levers Ignition SwitchRecoil Starter Grip Choke Control Operator Presence SwitchesGround Speed Control Neutral Lock Tracking AdjustmentThrottle Control Service Meter Parking BrakeBlade Engagement Control OptionalFuel Shutoff Valve Fuel TankOperation Before StartingStarting the Engine Speed control in the start position Running ReverseTracking Operating on HillsMowing Tips Stopping Emergency StopNormal operating stop Stopping the EngineShut OFF the fuel valve Cutting Height Adjustment Cutting Height TableIt may be necessary to readjust drive and brake linkages Cutting Height Table Maintenance Maintenance Schedule Daily Maintenance interval Least Hours Once Each Before AfterMaintenance Safety System Function CheckReplacing belt Tire PressuresDeck Belt Blade replacement Cutting BladesCleaning HardwareUnder side of rear deck WashingGeneral Front Wheel Bearings LubricationFront Wheel Mount Troubleshooting Problem CauseTroubleshooting Service Winter StorageLower Harness Harness Adapter Upper Harness Technical Data WH5218 Engine HEX Head CAP Screws CONForMITY Certificates USA requirementsService Journal Delivery ServiceHour Service After the first 8 hoursPerform the 25-hour service At Least Once Each Year Service Journal Page 115 392127R1 09/14/10