LUBRICATION
General
When lubricating with grease, unless otherwise stated, use only good quality molybdenum disulphide grease. Grease from
For daily use, the machine should be lubricated twice weekly.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts or the drive surfaces on the belt pulleys. Should this happen, attempt to clean them with spirits. If the belt continues to slip after cleaning, it must be replaced. Gasoline or other petroleum products must not be used to clean belts.
Deck spindle - Tunnel deck only.
Lower the cutting deck completely.
Lubricate with a grease gun, one zerk,
IMPORTANT INFORMATION
Use minimal lubrication and remove excess lubricant so that is does not come into contact with belts or belt pulley drive surfaces.
Deck spindle