Husqvarna WH3614A, WH3615A, WH4817A manual When a problem occurs, do not overlook the simple causes

Page 15

 

TROUBLE SHOOTING

PROBLEM

POSSIBLE CAUSES

 

 

 

 

Engine won’t start

1. Blade lever engaged.

 

2. Ground speed lever not in neutral.

 

3. Fuel valve closed.

 

4. No fuel.

 

5. Spark plug wires off.

 

6. Bad spark plugs.

 

7. Bad module.

Mower will not move

1. Pump bypass valves open.

or moves slowly or with

2. Pump drive belt loose or off.

difficulty

4. Hydraulic system failure.

 

5. Air in the hydraulic system.

 

 

Blades won’t engage

1. Blade belt off of pulleys.

 

2. Linkage unhooked or not adjusted.

 

 

Uneven cut

1. Tire pressure uneven.

 

2. Blades bent (check tip to tip one blade thickness)

 

3. Air foil of blade worn or bent.

 

 

Cut is ragged

1. Blades dull.

2. Ground speed too fast.

 

 

3. Grass accumulation under deck.

 

 

Mower moves when

1. Motion control linkage out of adjustment.

2. Pump arms loose or out of adjustment.

in neutral position

3. Short linkage out of adjustment.(see

 

 

motion control adjustment)

 

 

 

1. Tire pressure uneven.

Mower pulls left or right

2. Motion control linkage adjustment.

3. Soft terrain.

 

 

4. Slope too steep.

 

5. Tracking not adjusted.

When a problem occurs, do not overlook the simple causes.

15

Image 15
Contents Operators manual Models Technical Assistance Operating Instructions Safety Table of Contents MaintenanceSetup and Adjustments Trouble ShootingSafety Training PreparationOperation Safety Transportation Equipment Setup and AdjustmentsCutting Height Rear Deck Adjustment Cuttingheightadjustmentchart Motion Control AdjustmentReverse Spring Detent Adjustment Auxiliary Blade Belt Blade Drive Belt AdjustmentInterlock Safety System Engine Belt GuidesPump Belt Operating Instructions Controls Starting and Operation Maintenance Cutter Housing Spindle Assemblies When a problem occurs, do not overlook the simple causes