CUTTINGHEIGHTADJUSTMENTCHART
AXLE | NUMBER OF | NUMBER OF 1/4" BLADE SPACERS | CUTTING HEIGHT |
POSITION | SPACERS BELOW | UNDER CUTTER HOUSING | (IN INCHES) |
| CASTER ARM |
|
|
|
|
|
|
|
| 4 | 1 1/2 |
|
| 3 | 1 3/4 |
| 0 | 2 | 2 |
|
| 1 | 2 1/4 |
A |
| 0 | 2 1/2 |
|
|
| |
| 4 | 2 | |
|
| ||
|
| 3 | 2 1/4 |
| 1 | 2 | 2 1/2 |
|
| 1 | 2 3/4 |
|
| 0 | 3 |
|
|
|
|
|
| 4 | 2 1/2 |
| 2 | 3 | 2 3/4 |
| 2 | 3 | |
|
| ||
|
| 1 | 3 1/4 |
B |
| 0 | 3 1/2 |
|
| 4 | 3 |
|
| 3 | 3 1/4 |
| 3 | 2 | 3 1/2 |
|
| 1 | 3 3/4 |
|
| 0 | 4 |
|
| 4 | 3 1/2 |
|
| 3 | 3 3/4 |
| 4 | 2 | 4 |
|
| 1 | 4 1/4 |
C |
| 0 | 4 1/2 |
| 4 | 4 | |
|
| ||
|
| 3 | 4 1/4 |
| 5 | 2 | 4 1/2 |
|
| 1 | 4 3/4 |
|
| 0 | 5 |
Note: To quickly achieve small changes in cutting heights, move the spacers from under the cutter housing to above the cutter pulley. (Each spacer moved will give an additional 1/4" of cutting height ).
USE ONLY 4 BLADE SPACERS MAXIMUM
MOTION CONTROL ADJUSTMENT
1.This adjustment must be made with the drive wheels rotating. Raise rear of the unit and block it up so the wheels are free to rotate. CAUTION: Keep hands, feet and clothing away from rotating tires.
2.It will be necessary to make this adjustment with the reverse detents disconnected.
3.With the ground speed lever in neutral or stop position, start the engine.
4.The thumb latches should be unlocked.
5.Turn the adjusting nut the proper direction until the wheel stops rotating. This is your neutral position, repeat on other side. (see fig. 3)
6.After the neutral position is adjusted. You will need to readjust the short linkage. (see fig. 3)
7.Remove the two hairpins, swing the linkage out of the control lever and the thumb latch.
(see fig.3)
7