Husqvarna 339XP manual Technical Data, 336

TECHNICAL DATA

	336
Engine
Cylinder volume, cu.in/cm3	2,15/35,2
Cylinder bore, inch/mm	1,5/38
Stroke, inch/mm	1,22/31
Idle speed, rpm	2 800
Power, kW/ rpm	1,5/ 9 600
Ignition system
Manufacture	SEM
Type of ignition system	CD
Spark plug	NGK BPMR 7A
Electrode gap, inch/mm	Champion RCJ 7Y
	0,02/0,5
Fuel and lubrication system
Manufacturer	Zama
Carburetor type	C1Q EL20
Fuel capacity, US pint/litre	0,76/0,36
Oil pump capacity at 8 500 rpm, ml/min	3-7
Oil capacity, US pint/litre	0,43/0,2
Type of oil pump	Automatic
Weight
Without bar and chain, Lbs/kg	8,4/3,8
Chain/bar
Standard bar length, inches/cm	13"/33
Recommended bar lengths, inches/cm	12-16"/30-41
Usable cutting length, inches/cm	11-15"/28-38
Chain speed at max. power, m/sec	18,3
Pitch, inch	0,325"/8,25
Thickness of drive link, inch/mm	0,050"/1,3
Number of teeth on drive sprocket	7

Recommended original and replacement bar and chain combinations

Following is a list of recommended cutting equipment for the Husqvarna Model 336. The combinations of powerhead, bar and chain have been investigated in accordance with the kickback requirements of ANSI B

175.1– 2000. The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding maximum nose radius of a solid bar.

The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will also achieve kickback protection.

As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of of sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Low kickback saw chain is a chain which is has met the kickback performance requirements of ANSI B 175.1 safety requirements for gasoline-powered chain saws when tested on the representative sample of chain saws below 3.8 cu. in. specified in ANSI B 175.1. We recommend that you as replacement use the listed chains or "Low kickback saw chains" which are available at your dealer.

Guide bar			Saw chain
Length	Pitch	Max nose
inch	inch	radius
12	3/8	9T	Husqvarna S36x or Oregon 91VS
14	3/8	9T
16	3/8	9T
13	0,325	10T	Husqvarna H30 or Oregon 95VP

150,325 10T

160,325 10T

L

1

5

Type	Inch	Inch/mm	Inch/mm	Angle	Angle	Angle	Inch/mm	Inch/cm: dl
S36x	3/8"	0,050"/1,3	5/32" /4,5	60°	30°	0°	0,025"/0,65	12"/30:45	14"/34:52
91VS								16"/41:56
H30	0,325"	0,050"/1,3	3/16" /4,8	60°	30°	10°	0,025"/0,65	13"/33:56	15"/38:64
95VP								16"/41:66

34´®z+H*•¶5@¨

– English