USE
Start and stop
!WARNING!
There are rotating blades under the Auto Mower. Never put your hands or feet close to or under the body of the Auto Mower while the motor is running.
!WARNING!
Read carefully through the safety regulations in this Operator’s Manual before you start the Auto Mower.
Starting the Auto Mower
The battery must be charged before starting when the Auto Mower is new or has been stored for a long period, see “Charg- ing an empty battery”. In other cases the Auto Mower can be started at any time within the mowing area, according to the following:
•Lift the cover and switch on the switch. A long beep should be heard.
•Enter your personal code, * code #. On delivery the code is
*0000 #, see the “Settings” section to select your personal code.
•Lower the cover. The Auto Mower will either immediately start to mow or seek out the charging station. If the Auto Mower travels to the charging station with a fully charged battery it will leave after a short while. If the battery needs to be charged, it will remain there for sometime before leaving the charging station.
Stopping the Auto Mower
STOP
•Stop the Auto Mower by folding up the cover. Enter the first digit of the code to deactivate the theft alarm (*not neces- sary). Otherwise the alarm will start after approx. 6 seconds. The long beep confirms that cutting disc has stopped.
•Restart the Auto Mower by lowering the cover again.
•Always set the power switch to “STOP” if you intend to carry out any maintenance on the Auto Mower or to move it outside of the mowing area. When the switch is set to on, the per- sonal code, *code #, must be entered.
Adjusting the cutting height
STOP |
The cutting height can be adjusted to any height between around 3 (setting 1) and 9 cm (setting 5), which is roughly equivalent to
•Switch off the Auto Mower by lifting the cover, entering the first code digit of the code and switching off the switch.
•Turn the Auto Mower upside down and place it on a soft surface.
•Unscrew and loosen the height adjustment knobs to adjust the cutting height. Move the entire cutting motor up or down until the desired cutting height is reached. Then
Sprinkler system
The mower must not be operating if a sprinkler is installed. If a sprinkler system is used, the mower should be taken to a clear of the sprinkler range and the ON/STOP switch should be set to STOP.
English – 11