TROUBLE SHOOTING
Observation | Possible cause | Action |
The Auto Mower goes | If this only happens at certain places on | Check by moving the position of the |
outside the working area | the lawn it may be caused by metal | boundary wire. |
| objects (fencing, iron strengthening bars |
|
| etc.) or cables buried nearby. |
|
|
|
|
| The working area is sloping too steeply. | Ensure that the boundary wire has been |
|
| laid in accordance with the installation |
|
| instructions. |
|
|
|
| The boundary wire has been laid wrongly | Ensure that the boundary wire has been |
| around an “island”. | laid in accordance with the installation |
|
| instructions. |
|
|
|
| The boundary wire has been laid too | Ensure that the boundary wire has been |
| close to the edge of the area that you | laid in accordance with the installation |
| want to use as the working area. | instructions. |
|
|
|
|
|
|
Uneven mowing result | The Auto Mower is working too few | Lengthen the working time, see “Settings”. |
| hours each day. |
|
|
|
|
| The working area is too large. | Try reducing the size of the working area |
|
| or lengthening the working time, see |
|
| “Settings”. |
|
|
|
| The blades are blunt. | Change all three blades, to keep the |
|
| cutting disc balanced. |
|
|
|
| Grass is too long in relation to the set | Raise the mowing height. Gradually lower |
| cutting height. | the cutting height until the desired height |
|
| has been achieved. |
|
|
|
| Clumps of grass clippings on the cutting | Check that the protective plate and cutting |
| disc or around the motor shaft. | disc rotate freely and easily. If not, the |
|
| protective plate and possibly the cutting |
|
| disc must be removed to clean off grass |
|
| and foreign objects. |
|
|
|
|
|
|
The Auto Mower works at | The Auto Mower clock requires setting. | Set the clock, see “Settings”. |
the wrong time |
|
|
| The mowing start and stop times are | Set the mowing start and stop times |
| incorrectly set. | again, see “Settings”. |
|
|
|
|
|
|
The Auto Mower vibrates | Unbalanced cutting disc or damaged | Inspect the blades and replace them if |
| blades. | necessary. |
|
|
|
|
|
|
Auto Mower runs around | Auto Mower is searching for the charging | No action. The cutting disc does not rotate |
but the cutting disc does | station. | when the mower is searching for the |
not rotate. |
| charging station. |
|
|
|
|
|
|
The mower runs for | Grass or a foreign object is slowing down | Remove and clean the cutting disc and |
shorter periods than usual | the cutting disc or protective plate. | protective plate. |
between recharging. |
|
|
|
|
|
|
|
|
Mowing and charging | This is normal behaviour when the |
|
times are both shorter | temperature is high (gradually increasing |
|
than usual. | above 25°C). |
|
|
|
|
18 – English