Husqvarna YTH2042 TWIN owner manual Service and Adjustments

Page 18

SERVICE AND ADJUSTMENTS

A

B

FIG. 18

•ATTACH FRONT LINK (E) - Work from left side of tractor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F).

•Insert end of link (E) into hole in front mower bracket and secure with washer and retainer spring (J).

E

•ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin

(D) on rear mower bracket and secure with washer and retainer spring.

F

J

H

C

D

FIG. 19

FIG. 20

•Install belt on engine pulley (M), in belt keepers (G).

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

G MF

G

A E

B

C

D	FIG. 21

19

Image 18

Contents YTH2042 Twin General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents To Remove Tractor from Carton AssemblyUnassembled Parts Unpack CartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingSystem Characteristics To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerTo Operate on Hills Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OIL LevelTo Start Engine See Fig Purge TransmissionAutomatic Transmission Warm UP Mowing Tips General Recommendations MaintenanceMaintenance ScheduleBrake Operation BatteryTractor TiresEngine Cleaning IN-LINE Fuel Filter See FigService and Adjustments To Level Mower To Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig Belt RemovalFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Check Brake To Install Mower See Fig To Remove Mower See FigTo Attach Jumper Cables To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove CABLES, Reverse OrderTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Decals Wheels and TiresKEY Part Description Schematic Tractor Model NO. YTH2042 Twin 96041005400, Product no 41Electrical KEY Part NO. NO. Description Chassis KEY Part Description Drive 17 532 41 36-78 Spring, Brake Steering Assembly Spark Arrester KIT EngineSeat Assembly Mower Lift Mower Deck Tractor Model NO. YTH2042 Twin 96041005400, Product no 41 Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX532 41 00-15 Rev 05.21.07 CL