Husqvarna 335XPT manual Adjustment of the oil pump, Daily maintenance, Cooling system

1. Check the throttle trigger

for smooth operation. If

any binding occurs, or if

engine fails to return to

idle, the saw should be

taken to your dealer,

before it is used again.

Also, be sure that the

trigger cannot be pulled

until the throttle trigger

lockout is depressed.

2. Clean the chain brake

and check its function

according to the

instructions. Make sure

1

2

that the chain catcher is

undamaged. Otherwise

replace it immediately.

3. Clean or replace the air

filter as necessary. Check

for damage or holes.

4. The bar should be turned

daily for more even wear.

Check the lubrication hole

in the bar, to be sure it is

not clogged. Clean the

bar groove and lubricate

the bar sprocket tip.

3

4

5

1

2

3

4

5.

Check the function of the

oiler to be sure the bar

and chain receive proper

lubrication.

6.

Sharpen the chain and

check its tension and

condition. Check the drive

sprocket for wear.

Replace if necessary.

7.

Check the starter and

starter cord for wear or

damage. Clean the air

6

7

intake slots on the starter

housing.

8.

Check for any loose nuts

and screws and retighten

if necessary.

9.

Test the stop switch to be

sure it shuts off the

engine.

8

9