Husqvarna YTH20K46 Before Starting the Engine, To Operate on Hills, Service REMINDER/HOUR Meter

Page 11

OPERATION

WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary.

USING THE REVERSE OPERATION SYSTEM -

Only use if you are certain no children or other bystanders will enter the mowing area.

•Depress brake pedal all the way down.

•With engine running, turn ignition key counterclockwise to ROS "ON" position.

•Look down and behind before and while backing.

•Slowly depress reverse drive pedal to start move- ment.

•When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position.

ROS "ON" POSITION

ENGINE "ON" POSITION

 

(NORMAL OPERATING)

02828

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake.

•To restart movement, slowly release parking brake and brake pedal.

•Slowly depress appropriate drive pedal to slowest set- ting.

•Make all turns slowly.

TO TRANSPORT (See Figs. 3 and 11)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

•Raise attachment lift to highest position with attachment lift control.

•Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

•Do not push or tow tractor at more than two (2) MPH.

•To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting

 

your tractor on a truck or a trailer, be sure hood is closed

 

and secured to tractor. Use an appropriate means of tying

 

hood to tractor (rope, cord, etc.).

11

 

Transmission Engaged

Transmission Disengaged

FIG. 11

SERVICE REMINDER/HOUR METER

Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs servicing. When service is required, the service reminder will flash for two hours. To service engine and mower, see the Maintenance section of this manual.

NOTE: Service reminder runs when the ignition key is in any position but "STOP". For accurate reading, be sure key remains in the "STOP" position when engine is not running.

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

Page 10 Page 12
Image 11
Page 10 Page 12
Contents YTH20K46 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents To Remove Tractor from Carton AssemblyCheck Battery Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsCheck Engine OIL Level Service REMINDER/HOUR MeterBefore Starting the Engine To Operate on HillsAutomatic Transmission Warm UP To Start Engine See FigPurge Transmission Mowing Tips Schedule MaintenanceMaintenance General RecommendationsTires BatteryTractor Brake OperationEngine IN-LINE Fuel Filter See Fig CleaningMuffler Spark PlugsTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Drive Belt See Fig To Replace Mower Drive Belt See FigTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigTo Check Brake Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Tractor - Model Number YTH20K46 96043003300, Product no 43 SchematicElectrical KEY Part NO. NO. Description Chassis Tractor - Model Number YTH20K46 96043003300, Product no 43 Drive KEY Part Description Steering Assembly Engine 30!2+ª!22%34%2ª+4Seat Assembly Wheels and Tires DecalsMower Deck Tractor - Model Number YTH20K46 96043003300, Product no 43 Mower Lift Service Notes Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation532 41 04-50 11.14.06 TH
Related manuals
Manual 44 pages 37.67 Kb

YTH20K46 specifications

The Husqvarna YTH20K46 is a premier riding lawn mower designed for homeowners who seek efficiency, durability, and ease of use while maintaining their lawn. This versatile machine combines power and performance with advanced technologies, making it a reliable choice for various landscaping tasks.

One of the standout features of the YTH20K46 is its robust 20 HP Kohler engine, which provides ample power to handle even the toughest mowing conditions. The engine's design focuses on durability and efficiency, ensuring that users can tackle their larger lawns with ease and minimal maintenance. This riding mower is equipped with a 46-inch cutting deck, allowing for wide mowing swathes that significantly reduce mowing time while delivering an exceptional cut quality.

The mower employs an innovative automatic transmission system, which simplifies operation with a pedal-controlled system. This feature allows the operator to seamlessly adjust speed without the need for manual gear shifting, providing greater comfort during operation. The intuitive controls ensure tasks can be completed efficiently, even for less experienced users.

Another significant aspect of the YTH20K46 is its adjustable cutting height feature. Users can easily select from various cutting heights to achieve the desired lawn finish, ranging from 1.5 to 4 inches. This versatility is essential for adapting to different grass types and seasonal changes.

For added convenience, the Husqvarna YTH20K46 incorporates maintenance-friendly technology, such as an easy-access oil filter and a removable deck for quick blade sharpening or replacement. This attention to maintenance ensures that users can keep their mower in top working condition with minimal effort.

Ergonomics is also a key consideration in the design of this mower. The comfortable high-back seat provides excellent support during long mowing sessions, while the ergonomic steering wheel enhances maneuverability. Additionally, the mower features a built-in hour meter to keep track of maintenance intervals.

In summary, the Husqvarna YTH20K46 is an impressive riding mower that combines powerful performance, user-friendly features, and advanced technology. Its reliability and efficiency make it an ideal choice for homeowners looking to maintain their lawns effortlessly while achieving professional-quality results. With its durable construction and robust capabilities, the YTH20K46 stands out as a top contender in the riding mower category.
Top Page Image Contents