Husqvarna YTH20K46 owner manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents YTH20K46 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Check BatteryUnassembled Parts To Remove Tractor from CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Operate MowerService REMINDER/HOUR Meter Before Starting the EngineTo Operate on Hills Check Engine OIL LevelTo Start Engine See Fig Purge TransmissionAutomatic Transmission Warm UP Mowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBrake Operation TiresEngine Cleaning MufflerSpark Plugs IN-LINE Fuel Filter See FigService and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Mower Drive Belt See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic Tractor - Model Number YTH20K46 96043003300, Product no 43Electrical KEY Part NO. NO. Description Chassis Tractor - Model Number YTH20K46 96043003300, Product no 43 Drive KEY Part Description Steering Assembly 30!2+ª!22%34%2ª+4 EngineSeat Assembly Decals Wheels and TiresMower Deck Tractor - Model Number YTH20K46 96043003300, Product no 43 Mower Lift Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX532 41 04-50 11.14.06 TH
Related manuals
Manual 44 pages 37.67 Kb

YTH20K46 specifications

The Husqvarna YTH20K46 is a premier riding lawn mower designed for homeowners who seek efficiency, durability, and ease of use while maintaining their lawn. This versatile machine combines power and performance with advanced technologies, making it a reliable choice for various landscaping tasks.

One of the standout features of the YTH20K46 is its robust 20 HP Kohler engine, which provides ample power to handle even the toughest mowing conditions. The engine's design focuses on durability and efficiency, ensuring that users can tackle their larger lawns with ease and minimal maintenance. This riding mower is equipped with a 46-inch cutting deck, allowing for wide mowing swathes that significantly reduce mowing time while delivering an exceptional cut quality.

The mower employs an innovative automatic transmission system, which simplifies operation with a pedal-controlled system. This feature allows the operator to seamlessly adjust speed without the need for manual gear shifting, providing greater comfort during operation. The intuitive controls ensure tasks can be completed efficiently, even for less experienced users.

Another significant aspect of the YTH20K46 is its adjustable cutting height feature. Users can easily select from various cutting heights to achieve the desired lawn finish, ranging from 1.5 to 4 inches. This versatility is essential for adapting to different grass types and seasonal changes.

For added convenience, the Husqvarna YTH20K46 incorporates maintenance-friendly technology, such as an easy-access oil filter and a removable deck for quick blade sharpening or replacement. This attention to maintenance ensures that users can keep their mower in top working condition with minimal effort.

Ergonomics is also a key consideration in the design of this mower. The comfortable high-back seat provides excellent support during long mowing sessions, while the ergonomic steering wheel enhances maneuverability. Additionally, the mower features a built-in hour meter to keep track of maintenance intervals.

In summary, the Husqvarna YTH20K46 is an impressive riding mower that combines powerful performance, user-friendly features, and advanced technology. Its reliability and efficiency make it an ideal choice for homeowners looking to maintain their lawns effortlessly while achieving professional-quality results. With its durable construction and robust capabilities, the YTH20K46 stands out as a top contender in the riding mower category.
Top Page Image Contents