Husqvarna LTH1742T manual Before Starting the Engine, Check Engine OIL Level, ADD Gasoline

Page 14

OPERATION

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Unthread and remove oil fill cap/dipstick; wipe oil off. Reinsert the dipstick into the tube and rest oil fill cap on the tube. Do not thread the cap onto the tube. Remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F (0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP ENSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 6)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress brake pedal and set parking brake.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to fast position

•Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F and below)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Release the parking brake and let the brake slowly return to operating position.

•Allow one minute for transmission to warm up. This can be done during the engine warm up period.

•The attachments can be used during the engine warm- up period after the transmission has been warmed up and may require the choke control be pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32° F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents LTH1742TWIN General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts Steering WheelTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidAttach Hood Scoop See Fig Install Seat See FigsCheck Battery See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate on HillsTowing Carts and Other Attachments Service REMINDER/HOUR MeterTo Transport See Fig To Operate MowerADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Purge TransmissionGeneral Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine Muffler CleaningAIR Filter Spark PlugsTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Figs Raise attachment lift lever to highest position To Level Mower To Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionWith attachment clutch Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation 532 41 73-88 Rev 02.25.09 SR

LTH1742T specifications

The Husqvarna LTH1742T is a robust lawn tractor designed for homeowners who seek a reliable, efficient, and easy-to-use machine for maintaining their lawns. This model combines power, comfort, and innovative features that enable users to tackle various yard tasks with efficiency and ease.

One of the standout features of the LTH1742T is its powerful engine. Equipped with a 17-horsepower Briggs & Stratton single-cylinder engine, this lawn tractor can handle different terrains, providing ample power to cut through thick grass and tackle hilly landscapes. The engine is designed for ease of maintenance, ensuring that users can keep their machine in top condition without unnecessary hassle.

The cutting deck is another highlight of the LTH1742T. It comes with a 42-inch cutting width, making it suitable for medium to large yards. The deck features a triple-blade system, allowing for a clean and even cut, which not only enhances the appearance of your lawn but also promotes healthy grass growth. The cutting height is easily adjustable, offering six different positions so users can customize their mowing experience based on grass type and seasonal requirements.

The Husqvarna LTH1742T is designed with comfort in mind. The ergonomic seating provides ample support during long mowing sessions, while the steering wheel is positioned for optimal control. Another convenient feature is the easy-to-use automatic transmission, which allows for smooth acceleration and simple maneuvering without the need for constant gear shifting.

In terms of safety, the LTH1742T is equipped with an electric start system that eliminates the need for manual crank-starts. The safety features also include an operator presence switch, ensuring that the tractor will not operate unless the user is seated.

Additionally, this lawn tractor incorporates Husqvarna's innovative technologies such as the Air Induction Mowing Technology, which enhances airflow within the deck to provide superior cutting performance and ensures better grass collection.

Overall, the Husqvarna LTH1742T is engineered for efficiency, comfort, and performance. Its combination of power, cutting capabilities, and user-centric design makes it an excellent choice for homeowners looking to achieve a well-manicured lawn with minimal effort. Whether tackling overgrown areas or maintaining a well-kept yard, the LTH1742T stands out as a dependable workhorse ready for any challenge.
Top Page Image Contents