Husqvarna LTH1742T manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 26

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

26

Image 26
Contents LTH1742TWIN General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts Steering WheelTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidAttach Hood Scoop See Fig Install Seat See FigsCheck Battery See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate on HillsTowing Carts and Other Attachments Service REMINDER/HOUR MeterTo Transport See Fig To Operate MowerADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Purge TransmissionGeneral Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine Muffler CleaningAIR Filter Spark PlugsTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Figs Raise attachment lift lever to highest position To Level Mower To Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionWith attachment clutch Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation 532 41 73-88 Rev 02.25.09 SR

LTH1742T specifications

The Husqvarna LTH1742T is a robust lawn tractor designed for homeowners who seek a reliable, efficient, and easy-to-use machine for maintaining their lawns. This model combines power, comfort, and innovative features that enable users to tackle various yard tasks with efficiency and ease.

One of the standout features of the LTH1742T is its powerful engine. Equipped with a 17-horsepower Briggs & Stratton single-cylinder engine, this lawn tractor can handle different terrains, providing ample power to cut through thick grass and tackle hilly landscapes. The engine is designed for ease of maintenance, ensuring that users can keep their machine in top condition without unnecessary hassle.

The cutting deck is another highlight of the LTH1742T. It comes with a 42-inch cutting width, making it suitable for medium to large yards. The deck features a triple-blade system, allowing for a clean and even cut, which not only enhances the appearance of your lawn but also promotes healthy grass growth. The cutting height is easily adjustable, offering six different positions so users can customize their mowing experience based on grass type and seasonal requirements.

The Husqvarna LTH1742T is designed with comfort in mind. The ergonomic seating provides ample support during long mowing sessions, while the steering wheel is positioned for optimal control. Another convenient feature is the easy-to-use automatic transmission, which allows for smooth acceleration and simple maneuvering without the need for constant gear shifting.

In terms of safety, the LTH1742T is equipped with an electric start system that eliminates the need for manual crank-starts. The safety features also include an operator presence switch, ensuring that the tractor will not operate unless the user is seated.

Additionally, this lawn tractor incorporates Husqvarna's innovative technologies such as the Air Induction Mowing Technology, which enhances airflow within the deck to provide superior cutting performance and ensures better grass collection.

Overall, the Husqvarna LTH1742T is engineered for efficiency, comfort, and performance. Its combination of power, cutting capabilities, and user-centric design makes it an excellent choice for homeowners looking to achieve a well-manicured lawn with minimal effort. Whether tackling overgrown areas or maintaining a well-kept yard, the LTH1742T stands out as a dependable workhorse ready for any challenge.