Husqvarna LT1597 manual Mowing Tips, To Start Engine See Fig

Page 14

OPERATION

CAUTION: Alcohol blended fuels (called gas- ohol or using ethanol or methanol) can attract moisture which leads to separation and for- mation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place gear shift lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke () position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke ( ) position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke () position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-up period from several seconds to several minutes, depending on the tem- perature.

•The attachments can also be used during the engine warm-up period.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

MOWING TIPS

•Mower should be properly leveled for best mowing per- formance. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual.

•The left hand side of mower should be used for trim- ming.

•Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the machine. This will result in a more even distribution of clippings and more uniform cutting.

•When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until finished (See Fig. 11).

FIG. 11

•If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clip- pings. Make first cut relatively high; the second to the desired height.

•Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.

•Always operate engine at full throttle when mow- ing to assure better mowing performance and proper discharge of material. Regulate ground speed by se- lecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.

•When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents LT1597 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Contents of Hardware Pack Install Seat See Figs a and 2B Check Battery See FigAttach Hood Scoop See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Stopping See Figs HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigUsing the Reverse Operation System Reverse Operation System ROSBefore Starting the Engine Mowing Tips To Start Engine See FigMaintenance Lubrication ChartBlade Removal See Fig BatteryTractor Engine To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check Brake To Replace Motion Drive Belt See FigTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Replace Headlight BulbTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace FuseFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX532 41 01-85 03.05.07 JS

LT1597 specifications

The Husqvarna LT1597 is a robust riding mower designed for residential lawn care enthusiasts seeking efficiency and ease of use. With its powerful engine, advanced cutting technologies, and ergonomic design, the LT1597 is engineered to tackle a variety of lawn maintenance challenges while delivering exceptional performance.

At the heart of the LT1597 lies a durable engine that provides reliable power and performance. Featuring a Briggs & Stratton V-Twin engine, it ensures a smooth mowing experience with plenty of torque for tackling thick grass and uneven terrains. The engine's design promotes easy starting and minimal maintenance, allowing homeowners to focus more on lawn care and less on mowers.

One of the standout features of the LT1597 is its 97 cm (38-inch) cutting deck, which is optimized for achieving a precise cut over both flat and hilly landscapes. The deck comes equipped with a cutting system that utilizes three blades to produce consistent results while reducing clumping and ensuring a clean finish. Additionally, the cutting height can be easily adjusted, enabling users to customize their mowing height based on the season and lawn health.

Husqvarna integrates advanced technology into the LT1597 to enhance user experience. The mower features an ergonomic steering wheel and comfortable seating, providing a smooth ride even during extended mowing sessions. The dashboard includes easy-to-read indicators that keep track of crucial metrics such as fuel level and engine temperature, helping users stay informed during operation.

Another notable characteristic is the LT1597's maneuverability. With a tight turning radius, it allows users to navigate around flower beds, trees, and other obstacles with ease. The automatic transmission enhances the mowing experience further, providing a seamless transition between speeds and eliminating the need for manual gear shifting.

Safety is a top priority in the design of the LT1597. It includes features such as a safety switch that ensures the mower will stop if the operator leaves the seat, minimizing the risk of accidents. The robust build, combined with reliable components, ensures that the mower is built to last and withstand the demands of regular use.

In summary, the Husqvarna LT1597 stands out as a powerful, user-friendly riding mower, equipped with innovative features that make lawn care effortless. With its reliable engine, versatile cutting deck, ergonomic design, and commitment to safety, the LT1597 is a beneficial investment for those looking to maintain their lawns with professional results.
Top Page Image Contents