Husqvarna LT1597 manual Tractor, Blade Removal See Fig, Battery

Page 16

MAINTENANCE

TRACTOR

Always observe safety rules when performing any main- tenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO ADJUST BRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See “PRODUCT SPECIFICATIONS” section of this manual).

•Keep tires free of gasoline, oil, or insect control chemi- cals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OP- ERATION SYSTEM (ROS)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch en- gaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

ROS "ON" POSITION

ENGINE "ON" POSITION

 

(NORMAL OPERATING)

828

BLADE CARE

For best results mower blades must be sharp. Replace bent, worn or damaged blades.

CAUTION: Useonlyareplacementblade approved by the manufacturer of your tractor. Using a blade not approved by the manufacturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 12)

•Raise mower to highest position to allow access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new blade with stamped "THIS SIDE UP" facing deck and mandrel assembly.

IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly.

•Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: Special blade bolt is heat treated.

BLADE

 

 

MANDREL

 

 

 

ASSEMBLY

 

CENTER

 

 

 

HOLE

 

 

BLADE BOLT

 

 

 

(SPECIAL)

0

2

544

 

 

 

 

 

 

 

STAR

FIG. 12

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents LT1597 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Contents of Hardware Pack Install Seat See Figs a and 2B Check Battery See FigAttach Hood Scoop See Fig Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigStopping See Figs To USE Throttle Control D See FigTo Adjust Mower Cutting Height See Fig Using the Reverse Operation SystemTo Move Forward and Backward See Fig Reverse Operation System ROSBefore Starting the Engine Mowing Tips To Start Engine See FigMaintenance Lubrication ChartTractor BatteryBlade Removal See Fig Engine To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check Brake To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs See Fig To Replace Headlight BulbTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace FuseStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX532 41 01-85 03.05.07 JS

LT1597 specifications

The Husqvarna LT1597 is a robust riding mower designed for residential lawn care enthusiasts seeking efficiency and ease of use. With its powerful engine, advanced cutting technologies, and ergonomic design, the LT1597 is engineered to tackle a variety of lawn maintenance challenges while delivering exceptional performance.

At the heart of the LT1597 lies a durable engine that provides reliable power and performance. Featuring a Briggs & Stratton V-Twin engine, it ensures a smooth mowing experience with plenty of torque for tackling thick grass and uneven terrains. The engine's design promotes easy starting and minimal maintenance, allowing homeowners to focus more on lawn care and less on mowers.

One of the standout features of the LT1597 is its 97 cm (38-inch) cutting deck, which is optimized for achieving a precise cut over both flat and hilly landscapes. The deck comes equipped with a cutting system that utilizes three blades to produce consistent results while reducing clumping and ensuring a clean finish. Additionally, the cutting height can be easily adjusted, enabling users to customize their mowing height based on the season and lawn health.

Husqvarna integrates advanced technology into the LT1597 to enhance user experience. The mower features an ergonomic steering wheel and comfortable seating, providing a smooth ride even during extended mowing sessions. The dashboard includes easy-to-read indicators that keep track of crucial metrics such as fuel level and engine temperature, helping users stay informed during operation.

Another notable characteristic is the LT1597's maneuverability. With a tight turning radius, it allows users to navigate around flower beds, trees, and other obstacles with ease. The automatic transmission enhances the mowing experience further, providing a seamless transition between speeds and eliminating the need for manual gear shifting.

Safety is a top priority in the design of the LT1597. It includes features such as a safety switch that ensures the mower will stop if the operator leaves the seat, minimizing the risk of accidents. The robust build, combined with reliable components, ensures that the mower is built to last and withstand the demands of regular use.

In summary, the Husqvarna LT1597 stands out as a powerful, user-friendly riding mower, equipped with innovative features that make lawn care effortless. With its reliable engine, versatile cutting deck, ergonomic design, and commitment to safety, the LT1597 is a beneficial investment for those looking to maintain their lawns with professional results.
Top Page Image Contents