Husqvarna LT1597 manual Install Seat See Figs a and 2B, Check Battery See Fig

Page 6

ASSEMBLY

bolt and tighten securely.

Snap steering wheel insert into center of steering wheel.

Remove protective materials from tractor hood and grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.

 

INSERT

 

5/16 HEX BOLT

 

5/16 LOCK WASHER

 

LARGE FLAT WASHER

 

STEERING

 

WHEEL

STEERING BOOT

ADAPTER

 

TABS

TAB

 

 

SLOTS

EXTENSION SHAFT

 

LOWER STEERING SHAFT

 

 

03125

FIG. 2

INSTALL SEAT (See Figs. 2A and 2B)

• Remove bolt and flat washer securing seat to cardboard

packing and set aside for assembly of seat to tractor.

Remove the cardboard packing and discard.

• Connect switch to seat.

• Place seat on seat pan so all three (3) bottom pads

are positioned over large slotted holes in pan.

• Push down on seat to engage pads in slots and pull

seat towards rear of tractor.

• Raise seat and tighten bolt securely.

• Remove tape and discard.

• Lower seat into operating position and sit on seat.

Press clutch/brake pedal all the way down. If operating

SEAT

SWITCH

PAD

SLOT

SEAT

PAN

TAPE

WIRING HARNESS

FIG. 2A

SLOT

 

TAPE

PAD

 

 

FLAT

 

 

WASHER

 

 

SEAT PAN

 

BOLT

TAB

ADJUSTMENT

HANDLE

 

 

FIG. 2B

CHECK BATTERY (See Fig. 3)

Lift seat pan to raised position and open battery box door.

If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

SEAT PAN

LABEL

BATTERY

BOX DOOR

position is not comfortable, adjust seat.

To adjust seat: Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle.

TERMINAL

TERMINAL

02021

FIG. 3

6

Image 6
Contents LT1597 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Contents of Hardware Pack Install Seat See Figs a and 2B Check Battery See FigAttach Hood Scoop See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Stopping See Figs HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigUsing the Reverse Operation System Reverse Operation System ROSBefore Starting the Engine Mowing Tips To Start Engine See FigMaintenance Lubrication ChartBattery TractorBlade Removal See Fig Engine Service and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check Brake To Replace Motion Drive Belt See FigTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Replace Headlight BulbTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace FuseFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX532 41 01-85 03.05.07 JS

LT1597 specifications

The Husqvarna LT1597 is a robust riding mower designed for residential lawn care enthusiasts seeking efficiency and ease of use. With its powerful engine, advanced cutting technologies, and ergonomic design, the LT1597 is engineered to tackle a variety of lawn maintenance challenges while delivering exceptional performance.

At the heart of the LT1597 lies a durable engine that provides reliable power and performance. Featuring a Briggs & Stratton V-Twin engine, it ensures a smooth mowing experience with plenty of torque for tackling thick grass and uneven terrains. The engine's design promotes easy starting and minimal maintenance, allowing homeowners to focus more on lawn care and less on mowers.

One of the standout features of the LT1597 is its 97 cm (38-inch) cutting deck, which is optimized for achieving a precise cut over both flat and hilly landscapes. The deck comes equipped with a cutting system that utilizes three blades to produce consistent results while reducing clumping and ensuring a clean finish. Additionally, the cutting height can be easily adjusted, enabling users to customize their mowing height based on the season and lawn health.

Husqvarna integrates advanced technology into the LT1597 to enhance user experience. The mower features an ergonomic steering wheel and comfortable seating, providing a smooth ride even during extended mowing sessions. The dashboard includes easy-to-read indicators that keep track of crucial metrics such as fuel level and engine temperature, helping users stay informed during operation.

Another notable characteristic is the LT1597's maneuverability. With a tight turning radius, it allows users to navigate around flower beds, trees, and other obstacles with ease. The automatic transmission enhances the mowing experience further, providing a seamless transition between speeds and eliminating the need for manual gear shifting.

Safety is a top priority in the design of the LT1597. It includes features such as a safety switch that ensures the mower will stop if the operator leaves the seat, minimizing the risk of accidents. The robust build, combined with reliable components, ensures that the mower is built to last and withstand the demands of regular use.

In summary, the Husqvarna LT1597 stands out as a powerful, user-friendly riding mower, equipped with innovative features that make lawn care effortless. With its reliable engine, versatile cutting deck, ergonomic design, and commitment to safety, the LT1597 is a beneficial investment for those looking to maintain their lawns with professional results.