Installation
Instructions
LAKELAND4114.100
SINGLE CONTROL KITCHEN
Thank you for selecting
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds
Certified to comply with ANSI A112.18.1M
M968470 REV. 1. 4
TOOLS REQUIRED
Regular Screwdriver | Phillips Screwdriver | Adjustable Wrench |
| ||
|
| |
|
| Plumbers' Putty or Caulking |
1 INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON |
| |
CAUTION | Turn off hot and cold water |
| supplies before beginning. |
|
(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON with PUTTY PLATE (1). Insert supply HOSES (2) and SHANK (3) through hole of ESCUTCHEON with PUTTY PLATE (1) and mounting surface. Follow mounting instructions below to secure faucet to mounting surface.
(B) Installation less ESCUTCHEON (1). Discard ESCUTCHEON with PUTTY PLATE (1). Insert supply HOSES (2) and SHANK (3) through mounting hole and seat SPOUT BASE onto sink or mounting surface. Do not use putty.
Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside of sink or mounting surface. Hand tighten LOCKNUT (6) and check that rotation of HANDLE (7) from HOT to COLD is centered.
Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening the screws slightly each time until all are snug to ensure even pressure.
7 | 7 |
A | B |
SPOUT BASE
1
3
P U T T Y |
|
| 2 |
|
2 |
|
|
| |
|
|
|
| |
|
|
| 3 |
|
|
|
| SINK OR |
|
|
|
| MOUNTING | 4 |
|
| 4 | SURFACE | |
|
| 5 |
| 5 |
| 8 | 6 | 8 | 6 |
