American Standard 4114.1 Make Water Supply Connections, left supply to Hot Marked with a Red Line

Models: 4114.1

1 4
Download 4 pages 53.35 Kb
Page 3
Image 3
2 MAKE WATER SUPPLY CONNECTIONS

2 MAKE WATER SUPPLY CONNECTIONS

Turn off hot and cold water supplies before beginning.

Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect

left supply to Hot (Marked with a Red Line)

and right supply to Cold wall supply. Use

2

adjustable wrench to tighten connections.

 

Do not over tighten.

1

 

Faucet supplies are 21" long from faucet base.

Note: If additional supply length is required, installer must purchase additional parts separately.

Important: If SUPPLY HOSES (1, 2) are too long, loop as illustrated to avoid kinking.

COLD

HOT

3 CONNECT SPRAY HOSE

Slide COUPLING NUT (1) onto HOSE (2)

 

3

1

 

 

Place WASHER (3) into COUPLING NUT (1)

 

 

6

 

 

5

on HOSE (2). Thread COUPLING NUT (1) onto

 

 

 

 

 

HAND SPRAY (4) and tighten.

 

4

 

(May already be assembled).

 

 

Feed small end of HOSE (2) through BODY (5) so

 

2

HAND SPRAY (4) rests inside SPRAY HOLDER

(6).

 

 

 

Thread HOSE END (7) onto OUTLET HOSE ADAPTER (8) and tighten.

With HAND SPRAY (4) seated in SPRAY HOLDER (6),

install WEIGHTS (9) onto HOSE (2) using two SCREWS (10). Locate the WEIGHTS (9) two feet (2') from the underside of the sink deck. Tighten SCREWS (10) firmly.

 

 

24"

 

8

4 TEST INSTALLED FAUCET

With HANDLE (1) down in "off"

 

 

 

position.

 

 

7

Move HANDLE (1) down into "off"

Pull HAND SPRAY (2) from FAUCET (5)

 

 

position.

and disconnect HAND SPRAY (2). Be

9

10

 

Turn on water supplies.

careful not to lose WASHER (7). Pull

2

 

Check connections for leaks (See

HOSE (3) (HOSE should pull

 

 

 

approximately 2 feet) and direct open

 

 

 

Section 5).

 

 

 

HOSE END (4) into sink.

 

 

 

 

 

 

 

6

 

 

 

 

2

 

 

1

 

 

Operate handle up and down, in COLD and HOT positions, to

7

 

 

 

 

flush water lines thoroughly.

 

3

 

Place WASHER (7) into HOSE END (4) and connect

 

5

HAND SPRAY (2) to HOSE END (4). Place HAND SPRAY (2)

 

 

 

 

back into faucet.

 

 

 

 

 

 

Check HAND SPRAY (2) operation:

 

 

 

With faucet on push front of BUTTON (6) for a broad

 

 

 

cleansing spray.

4 left supply to Hot (Marked with a Red Line)3 CONNECT SPRAY HOSE4 TEST INSTALLED FAUCET

M968470 REV. 1. 4

Page 3
Image 3
American Standard 4114.1 Make Water Supply Connections, left supply to Hot Marked with a Red Line, Connect Spray Hose