Husqvarna 2246LS owner manual Important Check Belt for Proper Routing, ALL Mower Pulley Grooves

Page 19

SERVICE AND ADJUSTMENTS

A

B

FIG. 18

ATTACH FRONT LINK (E) - Work from left side of trac- tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F).

Insert end of link (E) into hole in front mower bracket and secure with washer and retainer spring (J).

E

ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin (D) on rear mower bracket and secure with washer and retainer spring.

F

J

H

FIG. 20

Install belt on engine pulley (M), in belt keepers (G).

C

IMPORTANT: CHECK BELT FOR PROPER ROUTING

IN ALL MOWER PULLEY GROOVES.

 

• Raise attachment lift lever to highest position.

D

• If necessary, adjust gauge wheels before operating

 

mower as shown in the Operation section of this

 

manual.

FIG. 19

M

F

G

 

R

 

G

 

 

Q

A

 

 

E

 

 

P

B

C

K

D

 

L

FIG. 21

 

 

19

Image 19
Contents 2246LS II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig Stopping See FigTo USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigTo Operate on Hills Service REMINDER/HOUR MeterBefore Starting the Engine Reverse Operation System ROSAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Lubrication Chart MaintenanceBlade Care TractorBrake Operation TiresEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig ALL Mower Pulley Grooves Important Check Belt for Proper RoutingTo Level Mower To Replace Motion Drive Belt See Fig To Replace Mower Drive Belt See FigFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Check BrakeTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Relay SchematicElectrical KEY Part Description 208 210 Chassis Drive Nut U-CHNL 1/4-20 550DP .350 PNL Engine Spark Arrester KITEngine Power Rating Information Steering Assembly 532 41 Wheel, Steering 532 19 532 40 Seat Seat AssemblyWheels and Tires DecalsMower Deck KEY Part NO. no Description 100 Mower LiftOnly Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation532 41 83-23 Rev 11.07.08 BAD