Husqvarna LTH1538 owner manual Install belt on engine pulley M, in belt keepers G

Page 20

SERVICE AND ADJUSTMENTS

A

B

FIG. 20

•ATTACH FRONT LINK (E) - Work from left side of trac- tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F).

•Insert end of link (E) into hole in front mower bracket and secure with washer and retainer spring (J).

E

•ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin (D) on rear mower bracket and secure with washer and retainer spring.

F

J

H

C

D

FIG. 22

•Hook end of clutch cable spring (Q) into hole in idler arm (R).

•Push clutch cable housing guide (P) into bracket, slide collar (L) onto guide and secure with retainer spring (K).

•Install belt on engine pulley (M), in belt keepers (G).

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

FIG. 21	G	M	F
Q	R		G
Q

		A	E

P

B

C

K	D
L	D	FIG. 23

20

Image 20

Contents LTH1538 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly To Remove Tractor from CartonBefore Removing Tractor from Skid Unpack CartonAdjust Seat See Fig Install Seat See FigsCheck Battery See Fig Attach Hood Scoop See Fig Steps 1, 2Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigStopping See Figs To USE Throttle Control D See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigUsing the Reverse Operation System To Move Forward and Backward See FigBefore Starting the Engine Automatic Transmission Warm UP Mowing TipsTo Start Engine Maintenance Lubrication ChartBlade Removal See Fig BatteryTractor Engine Cleaning Service and Adjustments To Install Mower See FigTo Remove Mower See Fig Into the Cable Guide on Front Edge of Lower DashInstall belt on engine pulley M, in belt keepers G To Level Mower To Check Brake To Replace Mower Drive Belt See FigTo Replace Motion Drive Belt See Fig To Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic Tractor - Model Number LTH1538 96043003800, Product no 43KEY Part Description DecalsWheels and Tires Electrical Socket Asm Bulb Twistlock Chassis 238 532 41 Trim 239 532 40 Clip Tinnerman Drive UNC 167 532 40 52-57 Latch Brake ParkingEngine Engine Power Rating Information Seat Assembly KEY PartSteering Assembly Mower Deck 532 40 30-12 Handle Clutch Cable Mower Lift Suggested Guide for Sighting Slopes for Safe Operation 532 41 07-13 REV1 12.07.06 TB