Husqvarna LT130 owner manual Off

Page 26

TROUBLESHOOTING POINTS

PROBLEM

CAUSE

CORRECTION

 

 

 

 

 

Engine continues to run

1.

Faulty operator-safety presence control system.

1.

Check wiring, switches and connections. If not

when operator leaves seat

 

 

 

corrected, contact an authorized service center/

with attachment clutch

 

 

 

department.

engaged

 

 

 

 

 

 

 

 

 

Poor cut - uneven

1.

Worn, bent or loose blade.

1.

Replace blade. Tighten blade bolt.

 

2.

Mower deck not level.

2.

Level mower deck.

 

3.

Buildup of grass, leaves, and trash under mower.

3.

Clean underside of mower housing.

 

4.

Bent blade mandrel.

4.

Replace blade mandrel.

 

5.

Clogged mower deck vent holes from buildup of

5.

Clean around mandrels to open vent holes.

 

 

grass, leaves, and trash around mandrels.

 

 

 

 

 

 

 

Mower blades will not

1.

Obstruction in clutch mechanism.

1.

Remove obstruction.

rotate

2.

Worn/damaged mower drive belt.

2.

Replace mower drive belt.

 

3.

Frozen idler pulley.

3.

Replace idler pulley.

 

4.

Frozen blade mandrel.

4.

Replace blade mandrel.

 

 

 

 

 

Poor grass discharge

1.

Engine speed too slow.

1.

Place throttle control in “FAST” position.

 

2.

Travel speed too fast.

2.

Shift to slower speed.

 

3.

Wet grass.

3.

Allow grass to dry before mowing.

 

4.

Mower deck not level.

4.

Level mower deck.

 

5.

Low/uneven tire air pressure.

5.

Check tires for proper air pressure.

 

6.

Worn, bent or loose blade.

6.

Replace/sharpen blade. Tighten blade bolt.

 

7.

Buildup of grass, leaves and trash under mower.

7.

Clean underside of mower housing.

 

8.

Mower drive belt worn.

8.

Replace mower drive belt.

 

9.

Blades improperly installed.

9.

Reinstall blades sharp edge down.

 

10.

Improper blades used.

10.

Replace with blades listed in this manual.

 

11. Clogged mower deck vent holes from buildup of

11.

Clean around mandrels to open vent holes.

 

 

grass, leaves, and trash around mandrels.

 

 

 

 

 

 

 

Headlight(s) not working

1.

Switch is “OFF”.

1.

Turn switch “ON”.

(if so equipped)

2.

Bulb(s) burned out.

2.

Replace bulb(s).

 

3.

Faulty light switch.

3.

Check/replace light switch.

 

4.

Loose or damaged wiring.

4.

Check wiring and connections.

 

5.

Blown fuse.

5.

Replace fuse.

 

 

 

 

 

Battery will not charge

1.

Bad battery cell(s).

1.

Replace battery.

 

2.

Poor cable connections.

2.

Check/clean all connections.

 

3.

Faulty regulator (if so equipped).

3.

Replace regulator.

 

4.

Faulty alternator.

4.

Replace alternator.

 

 

 

 

 

Engine “backfires”

1.

Engine throttle control not set at “SLOW”

1.

Move throttle control to “SLOW” position and allow

when turning engine

 

position for 30 seconds before stopping engine.

 

to idle for 30 seconds before stopping engine.

“OFF”

 

 

 

 

 

 

 

 

 

 

 

 

 

 

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents LT130 General Operation IV. ServiceSafe Operation Practices for Ride-On Mowers II. Slope OperationModel Number LT130 Serial Product SpecificationsCustomer Responsibilities Table of Contents Contents of Hardware Pack To Remove Tractor from CAR- TON AssemblyTools Required for Assembly Before Rollingtractor OFF SkidConnect Battery See Figs Install Seat See FigAssemble Gauge Wheels to Mower Deck See Fig Install Mulcher Plate See FigsTo Attach Nose Roller See Fig Check Deck Levelness To Convert to Bagging or DischargingCheck Tire Pressure Check for Proper Position of ALL BeltsOperation Know Your TractorHOW to USE Your Tractor To Transport Before Starting the EngineTo Operate on Hills ADD GasolineMulching Mowing Tips Mowing TipsTo Start Engine See Fig General Recommendations Lubrication ChartCustomer Responsibilities Before Each USEBrake Operation BatteryTractor TiresTransaxle Cooling EngineBelts LubricationSpark Plugs CleaningMuffler To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Replace Mower Blade Drive Belt See Fig To Adjust Brake See FigBelt Installation To Replace Motion Drive Belt See FigTransaxle Shifter Linkage and AD- Justment See Figs To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Remove Hood and Grill Assembly See FigTo Adjust Throttle Control Cable See Fig Interlocks and RelaysFinal Setting To Adjust Carburetor See FigPreliminary Setting Acceleration TestFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionOFF Schematic Tractor Model NO. LT130 954830071AElectrical KEY Part NO. NO. Description Chassis and Enclosures Bracket Pnt Fender Drive KEY Part NO. no Description Steering Assembly KEY Part Description NO. no Seat Assembly 532140838 SeatKEY Part Description DecalsWheels & Tires LBD48Optional Equipment EngineStud 1/4 turn Mower Deck 532141043 Guard TUV Idler Mower Lift Repair Parts Dana Transaxle Model Number Repair Parts Sighting Guide CUT This OUT Dotted Is a SlopeHusqvarna Forest & Garden CO Perimeter Woods Drive CHARLOTTE, North Carolina532150710 09.22.95 TR

LT130 specifications

The Husqvarna LT130 is a ride-on lawn mower designed for homeowners seeking efficiency, comfort, and precision in their lawn care tasks. This model strikes a balance between performance and ease of use, making it an ideal choice for those with medium to large-sized yards.

At the heart of the LT130 is its powerful engine, which provides robust performance for tackling various terrains and grass types. The mower is equipped with a reliable Briggs & Stratton engine that offers ample power while ensuring fuel efficiency. This feature is vital for homeowners who wish to maintain their lawns without incurring excessive operational costs.

One of the prominent features of the LT130 is its cutting deck, which measures 97 cm (approximately 38 inches) in width. This size allows for quick mowing sessions, reducing the time spent on lawn care while providing a clean and even cut. The adjustable cutting heights, ranging from 30 mm to 75 mm, give users the flexibility to customize the mower's performance according to their lawn conditions and preferences.

The LT130 incorporates Husqvarna's innovative Reverse Motion technology, which enables users to mow in reverse without having to disengage the cutting blades. This is particularly useful for navigating tight spaces, around flower beds, and obstacles, facilitating a more efficient mowing experience.

Comfort is a focal point in the design of the LT130. The ergonomically designed seating and controls ensure that users can operate the mower with minimal fatigue. The easily accessible controls are intuitive and designed for user-friendliness, making it suitable for inexperienced operators. Additionally, the integrated cup holder and storage compartment enhance the overall convenience of the mower.

The Husqvarna LT130 also features a durable build that can withstand the rigors of regular lawn maintenance. The rugged chassis and high-quality materials provide longevity and reliability, ensuring that the mower serves homeowners well for years to come.

For added versatility, the LT130 is compatible with various attachments, such as baggers and mulch kits, allowing users to manage grass clippings in different ways. This adaptability makes it a multi-functional tool for landscape management.

In summary, the Husqvarna LT130 is a robust ride-on lawn mower that combines power, efficiency, and comfort. With its strong engine, adjustable cutting deck, and user-friendly features, it caters to the needs of homeowners looking to maintain a healthy and attractive lawn. Its durability and adaptability further solidify its reputation as a wise investment for lawn care enthusiasts.
Top Page Image Contents