Husqvarna LGT24K54 HOW to USE Your Tractor, To SET Parking Brake See Fig, Stopping See Fig

Page 12

OPERATION

The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask worn over spectacles.

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE (See Fig. 17)

Your tractor is equipped with an operator presence sens- ing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

•Depress brake pedal (B) all the way down and hold.

•Pull parking brake lever (C) up and hold, release pres- sure from brake pedal (B), then release parking brake lever. Pedal should remain in brake position. Make sure parking brake will hold tractor secure.

C

B

Fig. 17

STOPPING (See Fig. 18)

MOWER BLADES -

•To stop mower blades, place attachment clutch control in the “DISENGAGED” position ().

 

 

 

 

 

(

 

) ATTACHMENT

(

) ATTACHMENT

 

 

 

 

CLUTCH SWITCH

 

CLUTCH SWITCH

 

 

“DISENGAGED”

 

“ENGAGED”

 

 

 

 

 

Fig. 18

GROUND DRIVE -

•To stop ground drive, depress brake pedal all the way down.

•Move motion control lever (J) to neutral position.

ENGINE -

•Move throttle control (D) between half and full speed (fast) position.

NOTE: Failure to move throttle control between half and full speed (fast) position, before stopping, may cause engine to “backfire”.

•Turn ignition key (F) to “STOP” position and remove key. Always remove key when leaving tractor to prevent unauthorized use.

•Never use the choke to stop the engine.

IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY TO DISCHARGE AND GO DEAD.

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause “browning” of grass. To eliminate this possibility, al- ways stop engine when stopping tractor on grass areas.

CAUTION: Always stop tractor com- pletely, as described above, and set parking brake before leaving the opera- tor's position.

TO USE THROTTLE CONTROL (D) (See Fig. 19)

Always operate engine at full speed (fast).

•Operating engine at less than full speed (fast) reduces engines operating efficiency.

•Full speed (fast) offers the best bagging and mower performance.

D

N

F

Fig. 19

TO USE CHOKE CONTROL (N) (See Fig. 19)

Use choke control whenever you are starting a cold engine. Do not use to start a warm engine.

•To engage choke control, pull knob out. Slowly push knob in to disengage.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents LGT24K54 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Rear 3/16 Lift Link Shoulder Bolt 1/4 O.DOil Drain Tube 4 O.DAssembly Tools Required for AssemblyBefore Removing Tractor from Skid Install ANTI-SWAY BAR S if Equipped See Turn Steering Wheel Left and Position Mower See FigANTI-SWAY BAR S Attach Mower Side Suspension Arms a to Chassis See Fig Attach Rear Lift Links C See FigAttach Front Link E See Fig Install Belt on Engine Clutch Pulley M See Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigStopping See Fig To USE Throttle Control D See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Move Forward and Backward See Fig To Operate MowerTo Stop Mower Blades Reverse Operation System ROSTo Operate on Hills To Transport See FigsService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionMaintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig Service and Adjustments To Install MowerTo Remove Mower See Fig To Replace Mower Blade Drive Belt See FigVisual SIDE-TO-SIDE Adjustment See Fig Precision SIDE-TO-SIDE Adjustment See FigTo Level Mower To Replace Motion Drive Belt See Fig To Check BrakeTo Remove Wheel for Repairs See Fig Front Wheel TOE-IN/CAMBERTransaxle Motion Control Lever Neutral Adjustment See Fig To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Attach Jumper CablesTransmission Other Fuel SystemEngine OIL CylindersTroubleshooting Problem Cause CorrectionTo run when oper Battery will notFires when turn Engine continuesSchematic Tractor Model NO. LGT24K54 96043012701, Product no 43Electrical KEY Part Description Chassis Tractor Model NO. LGT24K54 96043012701, Product no 43 Drive Bolt Rdhd Sqnk 3/8-16 x 2-3/4 Gr Engine 110KEY Part NO. NO. Description Steering Assembly Decals Wheels and TiresSeat Assembly Mower Deck 532 44 15-47 Deck Weldment Mower Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXLimitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart Qjlqh 7UDQVPLVVLRQ 02.22.11 CL
Related manuals
Manual 48 pages 13.97 Kb

LGT24K54 specifications

The Husqvarna LGT24K54 is a robust lawn tractor designed to meet the needs of homeowners who value both performance and comfort. It brings together cutting-edge technology and user-friendly features, making it a smart choice for maintaining lawns of various sizes.

One of the standout features of the LGT24K54 is its powerful 24 HP engine. The engine is a high-performance Kohler unit, providing ample power to tackle even the toughest grass and terrains. This ensures that users can complete their mowing tasks efficiently without worrying about whether their equipment can handle the job.

The tractor is equipped with a 54-inch cutting deck, which allows for a wide cutting path. This feature means mowing can be accomplished faster than with smaller decks, making it ideal for larger yards. The cutting height is adjustable, ranging from 1.5 inches to 4 inches, accommodating different grass types and personal preferences.

Husqvarna has introduced several technologies in the LGT24K54 to enhance the user experience. It features an ergonomic steering wheel and seat that provide comfort during extended use. In addition, the easy-to-use dashboard includes intuitive controls for engaging the cutting deck, adjusting speed, and more, ensuring that even novice users can operate the mower with ease.

Another impressive characteristic of the LGT24K54 is its hydrostatic transmission. This feature allows for seamless speed variations and provides a smooth driving experience without the need for manual gear shifting. It makes navigating around obstacles and tight corners much simpler.

The tractor also has a wide range of optional accessories, including baggers, mulch kits, and front attachments, making it a versatile machine throughout the year. Whether you need to collect grass clippings or tackle snow in winter, the LGT24K54 can adapt to your needs.

In terms of durability, the Jonsered LGT24K54 comes with a heavy-duty frame and steel cutting deck, ensuring long-lasting performance even in demanding conditions. The reinforced construction helps resist wear and tear, so users can depend on their equipment year after year.

In conclusion, the Husqvarna LGT24K54 is a powerful and versatile lawn tractor that combines robust engineering with user-friendly features. Ideal for homeowners looking for efficiency and comfort, it brings together advanced technologies and smart design to ensure a pleasant mowing experience and a pristine lawn.
Top Page Image Contents