Husqvarna LGT24K54 owner manual Tractor, Blade Care, Blade Removal See Fig, Battery

Page 18

MAINTENANCE

TRACTOR

Always observe safety rules when performing any maintenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See the sides of tires for proper PSI).

•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OPERATION SYSTEM (ROS) (See Fig. 27)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

 

 

 

 

 

 

 

 

 

 

02828

ROS "ON"

ENGINE "ON" POSITION

POSITION

(NORMAL OPERATING)

 

 

 

 

 

 

Fig. 27

18

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

CAUTION: Use only a replacement blade ap- proved by the manufacturer of your tractor. Using a blade not approved by the manu- facturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 28)

•Raise mower to highest position to allow access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new or resharpened blade with stamped "THIS SIDE UP" facing deck and mandrel assembly.

IMPORTANT: TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY.

•Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: SPECIAL BLADE BOLT HEAT TREATED.

MANDREL ASSEMBLY

 

BLADE

BLADE BOLT

STAR

(SPECIAL)

CENTER HOLE

Fig. 28

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE:Theoriginalequipmentbatteryonyourtractorismain- tenance free. Do not attempt to open or remove caps or cov- ers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•Raise hood.

•Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until bright.

•Coat terminals with grease or petroleum jelly.

•Reinstall battery (See “REPLACING BATTERY" in the Service and Adjustments section of this manual).

Page 17 Page 19
Image 18
Page 17 Page 19
Contents LGT24K54 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Oil Drain Tube Unassembled PartsRear 3/16 Lift Link Shoulder Bolt 1/4 O.D 4 O.DAssembly Tools Required for AssemblyBefore Removing Tractor from Skid Install ANTI-SWAY BAR S if Equipped See Turn Steering Wheel Left and Position Mower See FigANTI-SWAY BAR S Attach Mower Side Suspension Arms a to Chassis See Fig Attach Rear Lift Links C See FigAttach Front Link E See Fig Check Deck Levelness Install Belt on Engine Clutch Pulley M SeeCheck Tire Pressure Check for Proper Position of ALL BeltsOperation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerTo Operate on Hills To Stop Mower BladesReverse Operation System ROS To Transport See FigsCheck Engine OIL Level Service REMINDER/HOUR MeterBefore Starting the Engine ADD GasolineMowing Tips Purge TransmissionGeneral Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower To Replace Mower Blade Drive Belt See FigVisual SIDE-TO-SIDE Adjustment See Fig Precision SIDE-TO-SIDE Adjustment See FigTo Level Mower To Remove Wheel for Repairs See Fig To Replace Motion Drive Belt See FigTo Check Brake Front Wheel TOE-IN/CAMBERReplacing Battery See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig To Attach Jumper CablesTransmission Engine OIL OtherFuel System CylindersTroubleshooting Problem Cause CorrectionFires when turn To run when operBattery will not Engine continuesSchematic Tractor Model NO. LGT24K54 96043012701, Product no 43Electrical KEY Part Description Chassis Tractor Model NO. LGT24K54 96043012701, Product no 43 Drive Bolt Rdhd Sqnk 3/8-16 x 2-3/4 Gr Engine 110KEY Part NO. NO. Description Steering Assembly Decals Wheels and TiresSeat Assembly Mower Deck 532 44 15-47 Deck Weldment Mower Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXLimitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart Qjlqh 7UDQVPLVVLRQ 02.22.11 CL
Related manuals
Manual 48 pages 13.97 Kb

LGT24K54 specifications

The Husqvarna LGT24K54 is a robust lawn tractor designed to meet the needs of homeowners who value both performance and comfort. It brings together cutting-edge technology and user-friendly features, making it a smart choice for maintaining lawns of various sizes.

One of the standout features of the LGT24K54 is its powerful 24 HP engine. The engine is a high-performance Kohler unit, providing ample power to tackle even the toughest grass and terrains. This ensures that users can complete their mowing tasks efficiently without worrying about whether their equipment can handle the job.

The tractor is equipped with a 54-inch cutting deck, which allows for a wide cutting path. This feature means mowing can be accomplished faster than with smaller decks, making it ideal for larger yards. The cutting height is adjustable, ranging from 1.5 inches to 4 inches, accommodating different grass types and personal preferences.

Husqvarna has introduced several technologies in the LGT24K54 to enhance the user experience. It features an ergonomic steering wheel and seat that provide comfort during extended use. In addition, the easy-to-use dashboard includes intuitive controls for engaging the cutting deck, adjusting speed, and more, ensuring that even novice users can operate the mower with ease.

Another impressive characteristic of the LGT24K54 is its hydrostatic transmission. This feature allows for seamless speed variations and provides a smooth driving experience without the need for manual gear shifting. It makes navigating around obstacles and tight corners much simpler.

The tractor also has a wide range of optional accessories, including baggers, mulch kits, and front attachments, making it a versatile machine throughout the year. Whether you need to collect grass clippings or tackle snow in winter, the LGT24K54 can adapt to your needs.

In terms of durability, the Jonsered LGT24K54 comes with a heavy-duty frame and steel cutting deck, ensuring long-lasting performance even in demanding conditions. The reinforced construction helps resist wear and tear, so users can depend on their equipment year after year.

In conclusion, the Husqvarna LGT24K54 is a powerful and versatile lawn tractor that combines robust engineering with user-friendly features. Ideal for homeowners looking for efficiency and comfort, it brings together advanced technologies and smart design to ensure a pleasant mowing experience and a pristine lawn.
Top Page Image Contents