Husqvarna GTH26V52LS owner manual Tractor, Blade Care, Blade Removal See Fig, Battery

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any maintenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See the sides of tires for proper PSI).

•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OPERATION SYSTEM (ROS) (See Fig. 15)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

 

 

 

 

 

 

 

 

 

 

02828

ROS "ON"

ENGINE "ON" POSITION

POSITION

(NORMAL OPERATING)

 

 

 

 

 

 

Fig. 15

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

CAUTION: Use only a replacement blade ap- proved by the manufacturer of your tractor. Using a blade not approved by the manu- facturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 16)

•Raisemowertohighestpositiontoallowaccesstoblades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new or resharpened blade with stamped "THIS SIDE UP" facing deck and mandrel assembly.

IMPORTANT:TOENSUREPROPERASSEMBLY,CENTERHOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY.

•Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: SPECIAL BLADE BOLT HEAT TREATED.

MANDREL ASSEMBLY

 

BLADE

BLADE BOLT

STAR

(SPECIAL)

CENTER HOLE

Fig. 16

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE:Theoriginalequipmentbatteryonyourtractorismain- tenance free. Do not attempt to open or remove caps or cov- ers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•Raise hood.

•Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until bright.

•Coat terminals with grease or petroleum jelly.

•Reinstall battery (See “REPLACING BATTERY" in the SERVICEANDADJUSTMENTSsectionofthismanual).

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents GTH26V52LS II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Toremovetractorfromcarton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigTo Operate on Hills Using the Reverse Operation SystemTo Stop Mower Blades Reverse Operation System ROS See FigADD Gasoline Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OIL LevelMowing Tips Purge TransmissionAutomatic Transmission Warm UP Schedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig O P Service and AdjustmentsTo Install Mower See Fig To Remove Mower See FigSecure with small washer and small retainer spring as shown To Level Mower To Check Brake To Replace Mower Blade Drive BeltTo Remove Wheel See Fig Belt InstallationTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBERTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Remove CABLES, Reverse Order Transmission Engine OIL StorageOther Fuel SystemProblem Cause Correction TroubleshootingEngine continues KEY Part NO. NO. Description DecalsWheels and Tires KEY Part DescriptionSCH12 SchematicElectrical KEY Part Description 234 ChassisTractor Model NO. GTH26V52LS 96043011800, Product no 43 Drive G7-BCBB-1XDC-1FCA Spark Arrester KIT EngineSeat Assembly Steering Assembly 532 41 Wheel, Steering 532 19 Mower Deck Tractor Model NO. GTH26V52LS 96043011800, Product no 43     Mower LiftOnly Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation11.09.10 BAD

GTH26V52LS specifications

The Husqvarna GTH26V52LS is a versatile and high-performing lawn tractor designed for homeowners seeking efficiency and power in their mowing experience. With its robust construction and innovative features, this machine is ideal for tackling a variety of landscaping tasks with ease.

At the heart of the GTH26V52LS lies a strong 26 HP Kohler engine, ensuring reliable performance and the ability to handle larger properties. The engine is equipped with a hydrostatic transmission, which provides a seamless driving experience by allowing the operator to change speeds without the need for manual shifting. This feature makes it particularly user-friendly, as it enables smooth acceleration and greater control when navigating around obstacles.

One of the standout characteristics of the Husqvarna GTH26V52LS is its cutting deck. The 52-inch reinforced cutting deck offers a wide cutting path, enabling the user to cover more ground in less time. It features an air induction technology that enhances grass lift, resulting in an even and precise cut, regardless of the height or type of grass. The deck can be easily adjusted to different cutting heights, providing flexibility to meet individual lawn care needs.

Designed with user comfort in mind, the GTH26V52LS includes ergonomic features such as a high-back seat and easy-to-reach controls, allowing for extended periods of comfortable operation. The steering wheel is positioned for optimal maneuverability, which is essential when mowing in tight spaces or around landscaping features.

Another notable technology integrated into this lawn tractor is the automatic choke system, which simplifies the starting process by ensuring the engine starts quickly and efficiently in varying weather conditions. This innovation reduces the chances of flooding the engine and enhances overall reliability.

Durability is a key characteristic of the Husqvarna GTH26V52LS. Constructed with high-quality materials and precision-engineered components, this lawn tractor is built to withstand the rigors of regular use. Additionally, maintenance is made easy with accessible engine components and a removable cutting deck, allowing users to perform routine tasks without hassle.

In conclusion, the Husqvarna GTH26V52LS is an outstanding lawn tractor that combines power, comfort, and innovative technology to deliver exceptional mowing performance. Its user-friendly features and durability make it an excellent choice for homeowners looking to enhance their lawn care regimen.
Top Page Image Contents