Husqvarna GTH26V52LS owner manual To Level Mower

Page 20

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 30)

•With all tires properly inflated and if your lawn appears unevenly cut, determine which side of mower is cutting lower.

NOTE: As desired, you can raise the low side of mower or lower the high side.

•Go to side of mower you wish to adjust.

•With a 3/4" or adjustable wrench, turn lift link adjust- ment nut (A) to the left to lower the mower, or, to the right to raise the mower.

•If adjustment is necessary, see steps in Visual Adjust- ment instructions above.

•Recheck measurements, adjust if necessary until both sides are equal.

FRONT-TO-BACK ADJUSTMENT (See Figs. 32 & 33) IMPORTANT: Deck must be level side-to-side.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear tip when the mower is in its highest position.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•

Raise mower to highest position.

•

Position any blade so the tip is pointing straight forward.

TURN NUT RIGHT TO RAISE MOWER

A

TURN NUT LEFT

TO LOWER MOWER

Measure distance (B) to the ground at front and rear

tip of the blade.

BB

Fig. 32

•

If front tip of blade is not 1/8" to 1/2" lower than the

 

rear tip, go to the front of tractor.

•

With an 11/16" or adjustable wrench, loosen jam nut

 

A several turns to clear adjustment nut B.

Fig. 30

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

•Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.

PRECISION SIDE-TO-SIDE ADJUSTMENT (See Fig. 31)

•With all tires properly inflated, park tractor on level ground or driveway.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to its highest position.

•At both sides of mower, position blade at side and measure the distance (A) from bottom edge of blade to the ground. The distance should be the same on both sides.

 

02966

A

A

Fig. 31

• With a 3/4" or adjustable wrench, turn front link adjust-

ment nut (B) clockwise (tighten) to raise the front of mow-

er,or,counterclockwise(loosen)tolowerthefrontmower.

 

A

 

B

TIGHTEN

LOOSEN

ADJUST

ADJUST

NUT B

NUT B TO

TO RAISE

LOWER

MOWER

MOWER

 

LOOSEN JAM

 

NUT A FIRST

Fig. 33

NOTE: Each full turn of the adjustment nut will change mower height about 1/8".

•Recheck measurements, adjust if necessary until front tip of blade is 1/8" to 1/2" lower than the rear tip.

•Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents GTH26V52LS Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts ToremovetractorfromcartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigStopping See Fig To USE Throttle Control D See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigUsing the Reverse Operation System To Stop Mower BladesReverse Operation System ROS See Fig To Operate on HillsService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineAutomatic Transmission Warm UP Mowing TipsPurge Transmission Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Deck Washout Port See Fig CleaningIN-LINE Fuel Filter See Fig Service and Adjustments To Install Mower See FigTo Remove Mower See Fig O PSecure with small washer and small retainer spring as shown To Level Mower To Replace Mower Blade Drive Belt To Check BrakeBelt Installation To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel See FigTo Remove CABLES, Reverse Order To Start Engine with a Weak Battery See FigReplacing Battery See Fig Transmission Storage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionEngine continues Decals Wheels and TiresKEY Part Description KEY Part NO. NO. DescriptionSchematic SCH12Electrical KEY Part Description Chassis 234Tractor Model NO. GTH26V52LS 96043011800, Product no 43 Drive G7-BCBB-1XDC-1FCA Engine Spark Arrester KITSeat Assembly Steering Assembly 532 41 Wheel, Steering 532 19 Mower Deck Tractor Model NO. GTH26V52LS 96043011800, Product no 43 Mower Lift    Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX11.09.10 BAD

GTH26V52LS specifications

The Husqvarna GTH26V52LS is a versatile and high-performing lawn tractor designed for homeowners seeking efficiency and power in their mowing experience. With its robust construction and innovative features, this machine is ideal for tackling a variety of landscaping tasks with ease.

At the heart of the GTH26V52LS lies a strong 26 HP Kohler engine, ensuring reliable performance and the ability to handle larger properties. The engine is equipped with a hydrostatic transmission, which provides a seamless driving experience by allowing the operator to change speeds without the need for manual shifting. This feature makes it particularly user-friendly, as it enables smooth acceleration and greater control when navigating around obstacles.

One of the standout characteristics of the Husqvarna GTH26V52LS is its cutting deck. The 52-inch reinforced cutting deck offers a wide cutting path, enabling the user to cover more ground in less time. It features an air induction technology that enhances grass lift, resulting in an even and precise cut, regardless of the height or type of grass. The deck can be easily adjusted to different cutting heights, providing flexibility to meet individual lawn care needs.

Designed with user comfort in mind, the GTH26V52LS includes ergonomic features such as a high-back seat and easy-to-reach controls, allowing for extended periods of comfortable operation. The steering wheel is positioned for optimal maneuverability, which is essential when mowing in tight spaces or around landscaping features.

Another notable technology integrated into this lawn tractor is the automatic choke system, which simplifies the starting process by ensuring the engine starts quickly and efficiently in varying weather conditions. This innovation reduces the chances of flooding the engine and enhances overall reliability.

Durability is a key characteristic of the Husqvarna GTH26V52LS. Constructed with high-quality materials and precision-engineered components, this lawn tractor is built to withstand the rigors of regular use. Additionally, maintenance is made easy with accessible engine components and a removable cutting deck, allowing users to perform routine tasks without hassle.

In conclusion, the Husqvarna GTH26V52LS is an outstanding lawn tractor that combines power, comfort, and innovative technology to deliver exceptional mowing performance. Its user-friendly features and durability make it an excellent choice for homeowners looking to enhance their lawn care regimen.
Top Page Image Contents