Husqvarna GTH2448T owner manual ADD Gasoline, To Start Engine See Fig, Purge Transmission

Page 12

OPERATION

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place motion control lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to fast position

•Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F and below)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Place the motion control lever in neutral. Release the parking brake and let the clutch/brake slowly return to operating position.

•Allow one minute for transmission to warm up. This can be done during the engine warm up period.

•The attachments can be used during the engine warm-up period after the transmission has been warmed up and may require the choke control be pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is run-

ning.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

1.Place tractor safely on a level surface - that is clear and open - with engine off and parking brake set.

2.Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual).

3.Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) position, slowly dis- engage clutch/brake pedal.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents 917.279260 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Operate Mower Reverse Operation System ROSService REMINDER/HOUR Meter Before Starting the EngineTo Operate on Hills To Transport See FigsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance Before Each USEBattery TractorBrake Operation TiresEngine Cleaning MufflerSpark Plugs IN-LINE Fuel Filter See FigService and Adjustments To Install Mower See FigsTo Remove Mower See Fig To Level Mower Turn nut right Turn nut left To raise mower Mower Drive Belt Installation To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig Mower Drive Belt RemovalTo Start Engine with a Weak Battery See Fig Belt InstallationTo Check Brake Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Engine dies when Schematic Tractor Model no .279260 GTH2448T, Product no 43Electrical KEY Part NO. NO. Description Chassis KEY Part Description Drive KEY Part NO. NO. Description Steering Assembly Spark Arrester KIT EngineSeat Assembly Decals Wheels and TiresMower Deck Tractor Model no .279260 GTH2448T, Product no 43 Mower Lift Tractor Model no .279260 GTH2448T, Product no 43 900 Key Part Description Tractor - Model Number Briggs Engine Model Number 445677, Type Number 0476-E1Carburetor Gasket SET 789A 1054 789B 1070 668 526 501 1005 474 877 332 1059 573 KEY Part Description Repair Parts Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation Warranty Statement

GTH2448T specifications

The Husqvarna GTH2448T is a remarkable lawn tractor designed for homeowners with medium to large-sized yards. Combining power, efficiency, and innovative features, the GTH2448T enhances your mowing experience while ensuring impressive performance.

At the heart of the GTH2448T is a robust 24 HP Kohler engine. This powerful engine provides ample torque and reliability, making it ideal for handling various terrains and mowing conditions. The automatic transmission allows for smooth driving and easy operation, enabling users to navigate around obstacles and tight spaces with confidence.

One of the standout features of the Husqvarna GTH2448T is its 48-inch cutting deck. This deck size strikes an excellent balance between maneuverability and mowing efficiency, allowing users to cover larger areas quickly while still being able to access narrow paths. The cutting height is adjustable, with options ranging from 1.5 inches to 4 inches, ensuring that you can customize your lawn's appearance according to your preferences.

The GTH2448T comes equipped with a tight turning radius, enhancing its agility and allowing for easier navigation in confined spaces. This feature is particularly valuable when mowing around flower beds, trees, and other landscape features. Additionally, the mower's ergonomic design ensures a comfortable riding experience, with a plush seat and user-friendly controls that are within easy reach.

The Husqvarna GTH2448T employs several innovative technologies, including the Air Induction Mowing Technology. This feature enhances airflow within the deck, promoting an even cut and reducing the chance of clumping, which results in a cleaner lawn appearance. Moreover, the tractor's durable construction and high-quality materials offer long-lasting performance, ensuring that your investment will stand the test of time.

For added convenience, the GTH2448T is designed with an easy-to-access fuel tank and a maintenance-free battery, reducing downtime and simplifying upkeep. Optional accessories are available, including mulching kits and towable carts, expanding the tractor's versatility for various gardening tasks.

Overall, the Husqvarna GTH2448T stands out as an excellent choice for those seeking a reliable, efficient, and user-friendly lawn tractor. Its powerful engine, adjustable cutting deck, and advanced features make it an essential tool for maintaining a beautiful and well-manicured lawn. Whether you are a seasoned gardener or a novice homeowner, the GTH2448T offers everything needed to tackle your landscaping tasks effectively.
Top Page Image Contents