Husqvarna GTH2454T owner manual ADD Gasoline, To Start Engine See Fig, Purge Transmission

Page 15

OPERATION

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 13)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place motion control lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to fast position

•Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F and below)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Place the motion control lever in neutral. Release the parking brake and let the clutch/brake slowly return to operating position.

•Allow one minute for transmission to warm up.This can be done during the engine warm up period.

•The attachments can be used during the engine warm-up period after the transmission has been warmed up and may require the choke control be pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is run-

ning.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

•Place tractor safely on a level surface - that is clear and open - with engine off and parking brake set.

•Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual).

•Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) position, slowly dis- engage clutch/brake pedal.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents GTH2454T II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Mower Mower Front Wheel Unassembled PartsUnpack Carton AssemblyTools Required for Assembly To Remove Tractor from CartonFirst Install ANTI-SWAY BAR S Install Mower and Drive Belt7/16 Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor Stopping HOW to USE Your TractorReverse Operation System ROS To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerTo Transport See Figs Service REMINDER/HOUR MeterBefore Starting the Engine To Operate on HillsAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Maintenance Lubrication ChartBefore Each USE Tires BatteryTractor Brake OperationEngine IN-LINE Fuel Filter See Fig CleaningMuffler Spark PlugsTo Remove Mower Service and AdjustmentsTo Install Mower Tractor See FigTurn nut right Turn nut left To raise mower To Replace Motion Drive Belt See Fig To Replace Mower Blade Drive Belt See FigFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Check BrakeTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Tractor Model NO. GTH2454T 96043002300, Product no 43 SchematicElectrical KEY Part NO. NO. Description Chassis KEY Part Description Drive 211 532 19 62-12 Bushing Steering Assembly Engine Spark Arrester KITSeat Assembly Wheels and Tires DecalsMower Deck Tractor Model NO. GTH2454T 96043002300, Product no 43 Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Warranty Statement

GTH2454T specifications

The Husqvarna GTH2454T is a robust and versatile lawn tractor designed specifically for homeowners who require efficient lawn care and maintenance. This model exemplifies Husqvarna's commitment to innovation and quality, making it a popular choice for residential landscapers and gardening enthusiasts alike.

One of the standout features of the GTH2454T is its powerful 24 HP Briggs & Stratton Intek V-Twin engine, which delivers ample power for a variety of mowing conditions. This dual-cylinder engine is designed to provide smooth operation and high torque, ensuring that users can tackle even the toughest mowing tasks with ease. The hydrostatic transmission offers seamless speed control, allowing for precise adjustments while navigating different terrains or executing sharp turns.

The cutting deck on the GTH2454T is 54 inches wide, offering an efficient mowing experience by reducing the number of passes needed to cover large areas. The deck is reinforced with a durable design that withstands the rigors of regular use, and it features an adjustable cutting height, enabling users to customize their mowing height to match their lawn’s specific needs. This flexibility contributes to healthier grass growth and overall aesthetic appeal.

Additionally, the GTH2454T incorporates advanced features such as a responsive steering system, which enhances maneuverability and allows for easy navigation around obstacles like trees and flower beds. The ergonomic seat design ensures comfort during extended periods of use, while the convenient controls are intuitively placed for easy access.

Another noteworthy aspect of the Husqvarna GTH2454T is its compatibility with various attachments, making it a multi-functional tool for yard maintenance. Users can equip it with accessories like baggers, snow plows, and carts to extend its usability throughout the year, transforming it into a reliable ally in different seasonal tasks.

With its combination of power, versatility, and comfort, the Husqvarna GTH2454T is not just a lawn mower but a comprehensive solution for maintaining beautiful outdoor spaces. It stands as a testament to Husqvarna’s expert engineering and dedication to providing tools that meet the evolving needs of modern homeowners. Whether it’s tackling thick grass, managing foliage, or preparing for winter snow, the GTH2454T is an investment that can enhance any lawn care routine.
Top Page Image Contents