Husqvarna GTH220 owner manual Contents of Hardware Pack

Page 5

CONTENTS OF HARDWARE PACK

	Parts Bag contents shown full size
			(1) Shoulder Bolt
				5/16-18
		(1) Knob
			(1) Washer
			17/32 x 1-3/16 x 12 Gauge
			(3) Retainer Springs
			(double loop)
(4)	Retainer Springs (single loop)
	(4) Washers 13/32 x 13/16 x 16 Ga.
	(4) Carriage Bolts		(4) Crownlock Nuts	3/8-16
	3/8-16 x 1-1/4
	(2) Washers 17/32 x 7/8 x 16 Ga.
(2) Hex Bolts		3/8-16 x 1	(2) Nylon Locknuts	3/8-16
(2) Hex Bolts		1/4-20 x 3/4
			(2) Hex Nuts 1/4-20
(2) Washers 9/32 x 5/8 x 16 Ga. (2) Lock Washers 1/4

Parts packed separately in carton

Nose Roller

Seat

Front Bumper

Steering Wheel

	Manual		Parts Bag
	Manual
	Parts bag contents not shown full size
	(2) Shoulder			(2) Center-
	Bolts	(2) Washers	3/8	(2) Center-
	Bolts	(2) Washers	3/8	lock Nuts
		x 7/8 x 14 Gauge
	(2) Front Link Assemblies
	Nose	(2) Gauge
	Nose	Wheels
	Roller	Wheels
	Roller
	Brackets
				Steering
				Wheel
				Insert
				(2) Keys
	Slope Sheet

5

Image 5

Contents GTH220 Safe Operation Practices for Ride-On Mowers Safety RulesModel Number GTH220 Serial Product SpecificationsCustomer Responsibilities Table of Contents Contents of Hardware Pack Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Rolling Tractor OFF SkidTo Attach Nose Roller See Fig Install Seat See FigCheck Tire Pressure Check Brake SystemCheck for Proper Position of ALL Belts Install Mower and Drive Belt See FigsCheck Deck Levelness To Attach Front Bumper See Fig ChecklistLock Locked Reverse Neutral High LOW OperationUnlocked Know Your Tractor Height Adjustment Knob Used to adjust the mower heightHOW to USE Your Tractor To Operate Mower See Figs To Adjust Gauge Wheels See FigTo Operate on Hills To Transport See FigsBefore Starting the Engine Indicator LightsCheck Engine OIL Level See Fig ADD GasolinePurge Transmission Mowing TipsCustomer Responsibilities Lubrication ChartGeneral Recommendations Before Each USETractor BatteryBrake Operation TiresTransaxle Cooling EngineTransaxle Pump Fluid BeltsClean AIR INTAKE/COOLING Areas CleaningEngine OIL Filter MufflerTo Install Mower Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigTo Replace Mower Drive Belt FRONT-TO-BACK Adjustment See FigsTo Replace Mower Blade Drive Belt See Fig To Adjust Attachment Clutch See FigBelt Installation To Adjust Brake See FigTo Replace Motion Drive Belt See Fig Belt RemovalTransmission REMOVAL/REPLACEMENT To Adjust Motion Control Lever See FigTo Adjust Steering Wheel Alignment Front Wheel TOE-IN AdjustmentFront Wheel Camber To Start Engine with a Weak Battery See FigTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Remove Hood and Grill Assembly See Fig To Adjust Attachment Lift Spring See FigTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Choke Control See Figs To Adjust Throttle Control Cable See FigPreliminary Setting To Adjust Carburetor See FigFinal Setting Acceleration TestOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsOFF Service Notes Tractor Model NO. GTH220 954830167A SchematicElectrical Repair PartsKEY Part NO. NO. Description 47120 KEY Part Description Chassis and EnclosuresGround Drive Repair Parts Steering Assembly 532124415 Wheel, Steering 532137094 Engine KEY Part NO. NO. Description Seat Assembly Wheels & Tires DecalsGBD48 GSB42Lift Assembly Nut, Special Mower Deck KEY Part Description Transaxle Hydro Gear Model Number AYP Description Transaxle PUMP- Model Number BDU-10L-118 Service Notes Slope Sighting Guide CUT This OUT Dotted Is aLimited Warranty Warranty Statement532150629 08.17.95 Kfsw