Husqvarna GTH2752TF owner manual Secure with small washer and small retainer spring as shown

Page 19

SERVICE AND ADJUSTMENTS

•From right side of mower, first insert 90° end of anti-sway bar (S) into hole in transaxle bracket (T), located near left rear tire in front of transaxle.

NOTE: Flashlight may be helpful.

ANTI-SWAY BAR

TRANSAXLE

(S) LOCATION

BRACKET (T)

LOCATED

BETWEEN REAR

TIRES

 

S

T

S. ANTI-SWAY BAR

 

T. TRANSAXLE BRACKET

Fig. 24

NOTE: Depending on model, bracket (T) may be differ- ent than shown but hole for anti-sway bar will be in same position/location.

•Pivot the integrated washer end of anti-sway bar (S) towards mower deck bracket on right side of mower. Insert integrated washer end of bar into hole in rear mower bracket (D). Move mower as needed to insert integrated washer end of bar into rear mower bracket (D).

•Secure with small washer and small retainer spring as shown.

 

 

D. RIGHT SIDE

 

 

 

REAR MOWER

 

T

S

BRACKET

 

S. ANTI-SWAY BAR

 

 

D

 

T.

TRANSAXLE

 

 

BRACKET

 

 

 

Fig. 25

•ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

•Repeat on opposite side of tractor.

A

B

Fig. 26

•ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin on rear mower bracket (D) and secure with washer and retainer spring.

•Repeat on opposite side of tractor.

C

D

Fig. 27

•ATTACH FRONT LINK (E) - Work from left side of trac- tor. Insert threaded rod end of link assembly through front hole in tractor suspension bracket (F).

•Install bushing (O) and loosely install nut (P) and jam nut (Q).

•Insert flared ends of link (E) into slots in front mower bracket (H).

•Check Front-To-Back Adjustment in "TO LEVEL MOWER" in this section.

F

 

O

P

 

E

 

 

Q

H

 

Fig. 28

•Install belt onto electric clutch pulley (M).

M

Fig. 29

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

See Mower Drive Belt Installation in "TO REPLACE MOWER BLADE DRIVE BELT" in this section of the manual.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents GTH2752TF II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents To Remove Tractor from Carton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Dphg E CJK Know Your TractorStopping See Fig HOW to USE Your TractorAttachment Clutch Switch Disengaged Engaged To SET Parking Brake See FigTo USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigTo Operate on Hills Using the Reverse Operation SystemTo Stop Mower Blades Reverse Operation System ROS See FigADD Gasoline Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OIL LevelPurge Transmission Mowing TipsAutomatic Transmission Warm UP Schedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareEngine IN-LINE Fuel Filter See Fig CleaningDeck Washout Port See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install ANTI-SWAY BAR S if EquippedSecure with small washer and small retainer spring as shown To Level Mower To Check Brake To Replace Mower Blade Drive BeltTo Remove Wheel for Repairs See Fig Belt InstallationTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBERReplacing Battery See Fig To Start Engine with a Weak Battery see FIGTo Remove CABLES, Reverse Order Transmission Engine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine continues KEY Part NO. NO. Description DecalsWheels and Tires KEY Part DescriptionSCH12 SchematicTractor Model NO. GTH2752TF 96041017500, Product no 41 Electrical Chassis Tractor Model NO. GTH2752TF 96041017500, Product no 41 Drive G7-BCBB-1XDC-1FCA Engine Engine Power Rating Information Steering Assembly Tractor Model NO. GTH2752TF 96041017500, Product no 41 Seat Assembly    Mower LiftMower Deck Tractor Model NO. GTH2752TF 96041017500, Product no 41 Service Notes Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation 05.20.10 JA
Top Page Image Contents