Husqvarna GTH2752TF owner manual To Stop Mower Blades, Reverse Operation System ROS See Fig

Page 11

OPERATION

TO STOP MOWER BLADES

Disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield

(S) in place (See Fig. 10).

S

Fig. 10

REVERSE OPERATION SYSTEM (ROS) (See Fig. 11)

Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position.

WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary.

 

02828

ROS "ON"

ENGINE "ON" POSITION

POSITION

(NORMAL OPERATING)

Fig. 11

USING THE REVERSE OPERATION SYSTEM -

Only use if you are certain no children or other bystanders will enter the mowing area.

Depress brake pedal all the way down.

With engine running, turn ignition key counterclockwise to ROS "ON" position.

Look down and behind before and while backing.

Slowly depress reverse drive pedal to start movement.

When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position.

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

Choose the slowest speed before starting up or down hills.

Avoid stopping or changing speed on hills.

If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake.

To restart movement, slowly release parking brake and brake pedal.

Slowlydepressappropriatedrivepedaltoslowestsetting.

Make all turns slowly.

TO TRANSPORT (See Figs. 3 and 12)

When pushing or towing your tractor, be sure to disengage transmissionbyplacingfreewheelcontrolinfreewheeling po- sition.Freewheelcontrolislocatedatthereardrawbaroftractor.

Raise attachment lift to highest position with attachment lift control.

Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TRANSMISSION ENGAGED

TRANSMISSION DISENGAGED

Fig. 12

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

11

Image 11
Contents GTH2752TF II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents To Remove Tractor from Carton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Dphg E CJK Know Your TractorStopping See Fig HOW to USE Your TractorAttachment Clutch Switch Disengaged Engaged To SET Parking Brake See FigTo USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigTo Operate on Hills Using the Reverse Operation SystemTo Stop Mower Blades Reverse Operation System ROS See FigADD Gasoline Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OIL LevelAutomatic Transmission Warm UP Mowing TipsPurge Transmission Schedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareEngine Deck Washout Port See Fig CleaningIN-LINE Fuel Filter See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install ANTI-SWAY BAR S if EquippedSecure with small washer and small retainer spring as shown To Level Mower To Check Brake To Replace Mower Blade Drive BeltTo Remove Wheel for Repairs See Fig Belt InstallationTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBERTo Remove CABLES, Reverse Order To Start Engine with a Weak Battery see FIGReplacing Battery See Fig Transmission Engine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine continues KEY Part NO. NO. Description DecalsWheels and Tires KEY Part DescriptionSCH12 SchematicTractor Model NO. GTH2752TF 96041017500, Product no 41 Electrical Chassis Tractor Model NO. GTH2752TF 96041017500, Product no 41 Drive G7-BCBB-1XDC-1FCA Engine Engine Power Rating Information Steering Assembly Tractor Model NO. GTH2752TF 96041017500, Product no 41 Seat Assembly    Mower LiftMower Deck Tractor Model NO. GTH2752TF 96041017500, Product no 41 Service Notes Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation 05.20.10 JA