Sharp 36F630 operation manual How to identify a VCR, Direct Entry Method, Search Method

Models: 36F630

1 60
Download 60 pages 47.66 Kb
Page 42
Image 42

Operation of Universal Remote Control (Continued)

TV

POWER

REMOTE

KEYPAD

POWER (DVD/VCR)

CATV/DVD-TV/VCR

DISPLAY

CHANNEL

UP (a)/

DOWN (s)

How to identify a VCR

The remote control may already be set to operate your VCR. Try this initial check before going on to the following “identifying” section.

(1)Press TV/VCR button.

(2)Point the Remote towards VCR and press POWER (DVD/VCR).

(3)Does the Remote turn the VCR ON and OFF?

If yes, the Remote is ready to operate the VCR and no further steps are needed.

If no, continue to the “identifying” section.

Direct Entry Method

Refer to the following steps and list to quickly find the remote control code for your accessory VCR.

First look up your VCR’s remote control code number before going through the Direct Entry Method.

If this procedure does not identify your accessory VCR, use the Search Method of identification (described in the next section).

(1)Press TV/VCR button.

(2)Press and hold down DISPLAY and CH s on your remote control.

Then release both buttons.

(3)Within 10 seconds after releasing DISPLAY and CH s , enter your VCR’s two-digit remote control code number using the REMOTE KEYPAD (refer to the list on page 43).

The remote control is now ready to send commands to your VCR.

42

36F630(41-43)

42

Some brands have more than one remote code listed, due to changes in the remote codes from early to later model years, or due to format differences (VHS/BETA). In such cases, you may have to try more than one code to find the code your VCR accepts.

Note:

Depending on the model, year produced, brand, and type of VCR, some models may not be compatible with the remote control.

Search Method

(1)Press TV/VCR button.

(2)Press POWER of the VCR to ON.

(3)Stand at least 6 feet away from the front of the VCR.

Point the Remote towards the VCR.

Hold down DISPLAY and CH a at the same time. KEEP HOLDING THE BUTTONS DOWN.

(4)Watch the Channel Number indicator on the VCR, Channel numbers will scan up when the VCR has been identified.

Release DISPLAY and CH a as soon as the channel numbers start to scan up.

The VCR’s remote control code number has been identified, and the Remote is ready to operate the VCR.

03.3.5, 3:07 PM

Dimension: 140 X 215 mm

Page 42
Image 42
Sharp 36F630 operation manual How to identify a VCR, Direct Entry Method, Search Method