Husqvarna YTH24V42LS Service And Adjustments, TO REMOVE MOWER See Fig, TO INSTALL MOWER See Figs

Page 18
SERVICE AND ADJUSTMENTS

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

Depress brake pedal fully and set parking brake.

Place attachment clutch in “DISENGAGED” position.

Turn ignition key to “STOP” and remove key.

Make sure the blades and all moving parts have completely stopped.

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TO REMOVE MOWER (See Fig. 20)

Place attachment clutch in “DISENGAGED” position.

Lower attachment lift lever to its lowest position.

Remove mower belt from electric clutch pulley (M). See Mower Drive Belt Removal in "TO REPLACE MOWER BLADE DRIVE BELT" in this section.

Disconnect front link (E) from mower - remove retainer spring and washer.

Go to either side of mower and disconnect mower suspension arm (A) from chassis and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers.

Go to other side of mower and disconnect the suspen- sion arm and rear lift link.

CAUTION: After rear lift links are discon- nected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever.

Slide mower out from under right side of tractor.

TO INSTALL MOWER (See Figs. 20-25)

Be sure tractor is on level surface and engage parking brake.

Lower attachment lift lever to its lowest position.

CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position.

NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor.

Slide mower under tractor until it is centered under tractor.

ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

Repeat on opposite side of tractor.

A M

C

D

C

D

Fig. 20

F O P

Q

E

H

B

18

Image 18
Contents 532 44 Owners ManualYTH24V42LS 07002I. GENERAL OPERATION SAFETY RULESSafe Operation Practices for Ride-On Mowers II. SLOPE OPERATIONIV. TOWING V. SERVICEIII. CHILDREN GENERAL SERVICECUSTOMER RESPONSIBILITIES TABLE OF CONTENTSPRODUCT SPECIFICATIONS SERVICE AND ADJUSTMENTSTO CHECK BATTERY See Fig ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY TO ADJUST SEAT See FigCHECK FOR PROPER POSITION OF ALL BELTS CHECK TIRE PRESSURECHECK DECK LEVELNESS CHECK BRAKE SYSTEMOPERATION KNOW YOUR TRACTOR STOPPING See Fig HOW TO USE YOUR TRACTORTO SET PARKING BRAKE See Fig TO USE THROTTLE CONTROL D See FigTO MOVE FORWARD AND BACKWARD See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO ADJUST GAUGE WHEELS See Fig K J LTO OPERATE ON HILLS TO STOP MOWER BLADESREVERSE OPERATION SYSTEM ROS TO TRANSPORT See Figs. 3 andCHECK ENGINE OIL LEVEL SERVICE REMINDER/HOUR METERBEFORE STARTING THE ENGINE ADD GASOLINEMOWING TIPS PURGE TRANSMISSIONGENERAL RECOMMENDATIONS MAINTENANCEMAINTENANCE SCHEDULEBLADE CARE BATTERYTRACTOR BLADE REMOVAL See FigENGINE TRANSAXLE MAINTENANCECLEAN AIR SCREEN V-BELTSDECK WASHOUT PORT See Fig CLEANINGIN-LINE FUEL FILTER See Fig CAUTION Avoid all pinch points and movable parts See FigTO REMOVE MOWER See Fig SERVICE AND ADJUSTMENTSTO INSTALL MOWER See Figs A M C D C DSERVICE AND ADJUSTMENTS TO LEVEL MOWER IDLER ARM TO REPLACE MOWER BLADE DRIVE BELTTO CHECK BRAKE BELT ROUTING ENGINE BLADE BELTFRONT WHEEL TOE-IN/CAMBER TO START ENGINE WITH A WEAK BATTERY See FigTO REPLACE MOTION DRIVE BELT See Fig TO REMOVE WHEEL FOR REPAIRS See FigREMOVAL/REPLACEMENT REPLACING BATTERY See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig TO ADJUST THROTTLE CONTROL CABLEFUEL SYSTEM STORAGEOTHER ENGINE OILLoss of power TROUBLESHOOTINGPROBLEM CAUSEfires” when turn to run when operBattery will not Engine continuesPTO SWITCH SCHEMATICTRACTOR - MODEL NO. YTH24V42LS 96043011500, PRODUCT NO. 960 43 IGNITION SWITCHT15S TRACTOR - MODEL NO. YTH24V42LS 96043011500, PRODUCT NO. 960 43ELECTRICAL With 12V Outlet OptionELECTRICAL PARTDESCRIPTION CHASSIS chassis-texGT HUSQ II2r1PART DRIVE drive-texK46pedal72r2PART ENGINE SPARK ARRESTER KITengine-texKawa-2cyl5 PART STEERING ASSEMBLY Steering-texLEGND237Axle Asm., Front SEAT ASSEMBLY 532 42Seat DECALS WHEELS AND TIRESMOWER DECK PART MOWER LIFT 532 40 34-07 Link Lift Susp Mower RearSUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAX11.08.10 BAD Printed in the U.S.A