Husqvarna YTH24V42LS Interlocks And Relays, REPLACING BATTERY See Fig, To Replace Fuse, Engine

Page 23
INTERLOCKS AND RELAYS

SERVICE AND ADJUSTMENTS

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring.

WEAK OR

FULLY CHARGED

DEAD BATTERY

BATTERY

Fig. 35

REPLACING BATTERY (See Fig. 36)

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 37)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift hood to raised position.

•Remove terminal cover.

•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•Reinstall terminal cover.

•First connect RED battery cable to positive (+) battery terminal with bolt and nut as shown. Tighten securely.

HOOD

HEADLIGHT

WIRE

CONNECTOR

07002

Fig. 37

•Connect BLACK grounding cable to negative (-) battery TRANSMISSION terminal with remaining bolt and nut. Tighten securely

•Close hood.

NEGATIVE (BLACK)

CABLE

TERMINAL

COVER REPLACING BATTERY (See Fig. 36)TO REPLACE FUSETO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 37)TO REPLACE HEADLIGHT BULB

POSITIVE (RED)

CABLE

Fig. 36

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and beforeoperatingthetractor. See“PURGETRANSMISSION” in the Operation section of this manual.

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and adjust- ment should not be necessary. If adjustment is necessary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair

23and/or adjustment.

Page 22 Page 24
Image 23
Page 22 Page 24
Contents 07002 Owners ManualYTH24V42LS 532 44II. SLOPE OPERATION SAFETY RULESSafe Operation Practices for Ride-On Mowers I. GENERAL OPERATIONGENERAL SERVICE V. SERVICEIII. CHILDREN IV. TOWINGSERVICE AND ADJUSTMENTS TABLE OF CONTENTSPRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIESTO ADJUST SEAT See Fig ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY TO CHECK BATTERY See FigCHECK BRAKE SYSTEM CHECK TIRE PRESSURECHECK DECK LEVELNESS CHECK FOR PROPER POSITION OF ALL BELTSOPERATION KNOW YOUR TRACTOR TO USE THROTTLE CONTROL D See Fig HOW TO USE YOUR TRACTORTO SET PARKING BRAKE See Fig STOPPING See FigK J L TO ADJUST MOWER CUTTING HEIGHT See FigTO ADJUST GAUGE WHEELS See Fig TO MOVE FORWARD AND BACKWARD See FigTO TRANSPORT See Figs. 3 and TO STOP MOWER BLADESREVERSE OPERATION SYSTEM ROS TO OPERATE ON HILLSADD GASOLINE SERVICE REMINDER/HOUR METERBEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVELPURGE TRANSMISSION MOWING TIPSSCHEDULE MAINTENANCEMAINTENANCE GENERAL RECOMMENDATIONSBLADE REMOVAL See Fig BATTERYTRACTOR BLADE CAREV-BELTS TRANSAXLE MAINTENANCECLEAN AIR SCREEN ENGINECAUTION Avoid all pinch points and movable parts See Fig CLEANINGIN-LINE FUEL FILTER See Fig DECK WASHOUT PORT See FigA M C D C D SERVICE AND ADJUSTMENTSTO INSTALL MOWER See Figs TO REMOVE MOWER See FigF O P Q E H B TO LEVEL MOWER BELT ROUTING ENGINE BLADE BELT TO REPLACE MOWER BLADE DRIVE BELTTO CHECK BRAKE IDLER ARMTO REMOVE WHEEL FOR REPAIRS See Fig TO START ENGINE WITH A WEAK BATTERY See FigTO REPLACE MOTION DRIVE BELT See Fig FRONT WHEEL TOE-IN/CAMBERTO ADJUST THROTTLE CONTROL CABLE REPLACING BATTERY See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig REMOVAL/REPLACEMENTENGINE OIL STORAGEOTHER FUEL SYSTEMCAUSE TROUBLESHOOTINGPROBLEM Loss of powerEngine continues to run when operBattery will not fires” when turnIGNITION SWITCH SCHEMATICTRACTOR - MODEL NO. YTH24V42LS 96043011500, PRODUCT NO. 960 43 PTO SWITCHWith 12V Outlet Option TRACTOR - MODEL NO. YTH24V42LS 96043011500, PRODUCT NO. 960 43ELECTRICAL T15SDESCRIPTION ELECTRICALPART chassis-texGT HUSQ II2r1 CHASSISPART drive-texK46pedal72r2 DRIVEPART engine-texKawa-2cyl5 ENGINESPARK ARRESTER KIT DESCRIPTION Steering-texLEGND237 STEERING ASSEMBLYAxle Asm., Front Seat SEAT ASSEMBLY532 42 WHEELS AND TIRES DECALSMOWER DECK DESCRIPTION 532 40 34-07 Link Lift Susp Mower Rear MOWER LIFTONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAX SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATIONPrinted in the U.S.A 11.08.10 BAD
Top Page Image Contents