Husqvarna YTH24V54 owner manual Attach Mower Side Suspension Arms a to Chassis See Fig

Page 8

ASSEMBLY

ANTI-SWAY BAR	TRANSAXLE
(S) LOCATION	BRACKET (T)

LOCATED

BETWEEN REAR

TIRES

	S
T	S. ANTI-SWAY BAR
	T. TRANSAXLE BRACKET

Fig. 10

NOTE: Depending on model, bracket (T) may be differ- ent than shown but hole for anti-sway bar will be in same position/location.

•Pivot the integrated washer end of anti-sway bar (S) towards mower deck bracket on right side of mower. Insert integrated washer end of bar into hole in rear mower bracket (D). Move mower as needed to insert integrated washer end of bar into rear mower bracket (D).

•Secure with small washer and small retainer spring as shown.

		D. RIGHT SIDE
			REAR MOWER
	T	S	BRACKET
	T	S. ANTI-SWAY BAR
		S. ANTI-SWAY BAR
D		T.	TRANSAXLE
D			BRACKET
			BRACKET

Fig. 11

6.ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS (See Fig. 12)

•Position front hole in side suspension arm (A) over pin on outside of tractor chassis and secure with large washer and large retainer spring (B).

•Repeat on opposite side of tractor.

				A.MOWER SIDE
				SUSPENSION
				ARMS
				B. RETAINER
				SPRING
				D. RIGHT
				SIDE REAR
	D	A	B	MOWER
	D	A	B	BRACKET
				BRACKET

Fig. 12

7. ATTACH REAR LIFT LINKS (C) (See Fig. 13)

•Insert rod end of rear lift link (C) into hole (U) in tractor lift shaft suspension arm and pivot link down to mower.

•Lift rear corner of mower and position slot in link as- sembly over pin on rear mower bracket (D) and secure with large washer and large retainer spring.

•Repeat on opposite side of tractor.

U

C

		C. REAR LIFT LINK(S)
		D. RIGHT SIDE REAR
	D	MOWER BRACKET
	D	U. HOLE
		U. HOLE

Fig. 13

8 ATTACH FRONT LINK (E) (See Fig. 14)

•Turn steering wheel to position wheels straight forward.

•From front of tractor, insert rod end of front link (E) through front hole in tractor front suspension bracket (F).

•Move to left side of mower and and insert large retainer spring (G) through hole in front link (E) behind front suspension bracket (F).

•Insert other end of link (E) into hole in front mower bracket (H) and secure with washer and small retainer spring (J).

NOTE: Requires deck lifting.

FRONT LINK

LOCATION

M

H

F

G E

J

E.FRONT LIFT LINK ASSEMBLY

F.FRONT SUSPENSION BRACKET

G.LARGE RETAINER SPRING

H.FRONT MOWER BRACKET

J.SMALL RETAINER SPRING M. ENGINE CLUTCH PULLEY

Fig. 14

8

Image 8

Contents 917.289640 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Mower Mower Front WheelSlope Sheet KeysAssembly Tools Required for AssemblyToremovetractorfromcarton Before Removing Tractor from SkidANTI-SWAY BAR S Install ANTI-SWAY BAR S if Equipped SeeTurn Steering Wheel Left and Position Mower See Fig Attach Front Link E See Fig Attach Mower Side Suspension Arms a to Chassis See FigAttach Rear Lift Links C See Fig Install Belt on Engine Clutch Pulley M See Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor To SET Parking Brake See FigStopping See Fig To USE Throttle Control D See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To USE Cruise Control J See FigUsing the Reverse Operation System To Stop Mower BladesReverse Operation System ROS To Operate on HillsService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionMaintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBrake Operation TiresEngine Deck Washout Port See Fig CleaningIN-LINE Fuel Filter See Fig Service and Adjustments To Install MowerTo Remove Mower See Fig To Replace Mower Blade Drive Belt See FigTo Level Mower Belt Installation To Check BrakeTo Replace Motion Drive Belt See Fig To Remove Wheel See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigFront Wheel TOE-IN/CAMBER To Attach Jumper CablesTransmission Storage OtherFuel System Engine OILProblem Cause Correction To run when oper Battery will notFires when turn Engine continuesSchematic Tractor Model NO. YTH24V54Electrical Electrical KEY Part DescriptionChassis Tractor Model NO. YTH24V54 Drive 197KEY Part NO. NO. Description 30!2+ª!22%34%2ª+4 EngineEngine Power Rating Information Steering Assembly KEY Part NO. NO. Description Mower Deck 532 40 31-25 Deck Weldment Mower Mower Lift Seat Assembly Decals Wheels and TiresBriggs Engine Model 445677, Type Number 1198-B1 Liquid Gasket and the Breather Gasket are InterchangeableTractor Model NO. YTH24V54 967 628 385 601A 918 240 334 788 387 526 474 693997 Tractor Model NO. YTH24V54 Tractor - Model Number YTH24V54 Tufftorq Transaxle Model Number K46BTTractor - Model Number YTH24V54 Service Notes Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXWarranty Statement