Husqvarna YTH23V48 owner manual Transmission

Page 24

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Fig. 41)

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.

Lift hood to raised position.

Remove terminal cover.

Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

Install new battery with terminals in same position as old battery.

Reinstall terminal cover.

First connect RED battery cable to positive (+) battery terminal with bolt and nut as shown. Tighten securely.

Connect BLACK grounding cable to negative (-) battery terminal with remaining bolt and nut. Tighten securely

Close hood.

NEGATIVE (BLACK)

CABLE

TERMINAL

COVER

POSITIVE (RED)

CABLE

Fig. 41

TO REPLACE HEADLIGHT BULB

Raise hood.

Pull bulb holder out of the hole in the backside of the grill.

Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 42)

Raise hood.

Unsnap headlight wire connector.

Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

07002

Fig. 42

TRANSMISSION

REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and beforeoperatingthetractor. See“PURGETRANSMISSION” in the Operation section of this manual.

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and adjust- ment should not be necessary. If adjustment is necessary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

24

Image 24
Contents YTH23V48 Safe Operation Practices for Ride-On Mowers General OperationII. Slope Operation Service General ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly ToremovetractorfromcartonBefore Removing Tractor from Skid Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigStopping See Fig To USE Throttle Control D See FigTo Operate Mower To Stop Mower BladesService REMINDER/HOUR Meter Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionMaintenance Lubrication ChartGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning MufflerIN-LINE Fuel Filter See Fig Deck Washout Port See FigTo Install Mower See Figs To Remove Mower See FigANTI-SWAY BAR S Turn Steering Wheel Left and Position Mower See FigAttach Mower Side Suspension Arms a to Chassis See Fig Mower Drive Belt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Level MowerBelt Installation To Replace Motion Drive Belt See FigBelt Removal To Start Engine with a Weak Battery See Fig To Remove Wheel See FigFront Wheel TOE-IN/CAMBER To Attach Jumper CablesTransmission Other Fuel SystemEngine OIL CylindersTroubleshooting Problem Cause CorrectionEngine continues Decals Wheels and TiresKEY Part NO. NO. Description Schematic SCH12Electrical KEY Part Description Chassis Chassis Drive 196Bolt Rdhd Sqnk 3/8-16 x 2-3/4 Gr Spark Arrester KIT EngineEngine Power Rating Information Steering Assembly Seat Assembly Mower Deck KEY Part NO. NO. Description Mower Lift Limitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart Front Mounted Deck Riders Engine Transmission Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX10.27.10 JA