This product satisfies CE regulations when shielded cables and connectors are used to connect the unit to other equipment.
To prevent electromagnetic interference with electric appliances, such as radios and televisions, use shielded cables and connectors for connections.
IMPORTANT NOTEThe mains lead on this equipment is supplied with a moulded plug incorporating a fuse. The value of the fuse is indicated on the pin face of the plug.
If it requires replacing, a fuse approved to BS1362 of the same rating must be used. Never use the plug with the fuse cover omitted if the cover is detachable. If a replacement fuse cover is required, it must be of the same colour as the pin face of the plug. Replacement covers are available from your dealer.
If the fitted plug is not suitable for the power points in your house or the cable is not long enough to reach a power point, you should obtain a suitable safety approved extension lead or consult your dealer for assistance.
However, if there is no alternative to cutting off the plug, remove the fuse and then safely dispose of the plug. Do not connect the plug to a mains jack, as there is a risk of shock hazard from the bared flexible cord.
To disconnect the apparatus from the mains, the plug must be pulled out from the mains socket, therefore the mains plug shall be readily operable.
The product unit accompanying this user manual is licensed under certain intellectual property rights of certain third parties.
Precautions
Important Safety InstructionsRead these operating instructions carefully before using the unit. Follow all the safety instructions listed below.
Keep these operating instructions handy for future reference.
111 Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with the
888 manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including AV receivers) that produce heat.
999 Do not defeat the safety purpose of the polarized or
1111 Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
1111 Only use attachments/accessories specified by the manufacturer.
1111 Use only with the cart, stand, tripod, bracket, or table
specified by the manufacturer,
or sold with the apparatus. When a
cart is used, use caution when moving the cart/apparatus combination to avoid injury from
1111 Unplug this apparatus during lightning storms or when unused for long periods of time.
1111 Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as when
Disc Storage & Management
Disc HandlingDisc Shape•• Use discs with regular shapes. If you use an irregular disc (a disc with a special
shape), you can damage the player.
Holding discs•• Avoid touching the surface of a disc where data has been recorded.
•• Do not leave a
•• Be careful not to scratch or leave fingerprints on the surface of the
•• Wipe off dirt or contamination on the disc with a soft cloth.
Disc StorageBe careful not to damage the disc because the data on these discs is highly vulnerable to the environment.
•• Do not keep under direct sunlight.
•• Keep in a cool ventilated area.
•• Store vertically.
•• Keep in a clean, protective jacket.
•• If you move your player suddenly from a cold place to a warm place, condensation may occur on the operating parts and lens and cause abnormal disc playback. If this occurs, unplug the player, wait for two hours, and then connect the plug to the power outlet. Then, insert the disc, and try to play back again.
Handling Cautions•• Do not write on the printed side with a ball- point pen or pencil.
•• Do not use record cleaning sprays or antistatic sprays to clean discs. Also, do not use volatile chemicals, such as benzene or thinner.
•• Do not apply labels or stickers to discs. (Do not use discs fixed with exposed tape adhesive or leftover
•• Do not use
3