Wiring instructions
WARNING THIS APPLIANCE MUST BE EARTHED.
This appliance must be earthed. In the event of an electrical short circuit, earthing reduces the risk of electric shock providing an escape wire for the electric current.
The appliance is equipped with a mains lead which includes an earth wire for connecting to the earth terminal of your mains plug. The plug must be plugged into a socket that is properly installed and earthed.
The wires in this mains lead are coloured in accordance with the following code:
• | : Earth | |
• | Blue | : Neutral |
• | Brown | : Live |
GREEN AND YELLOW
BLUE
13AMP FUSE
BROWN
WARNING
Ensure that the plug and power cord are not damaged before use.
If you have any reason to remove the moulded plug from this appliance, immediately remove the fuse and dispose of the plug.
Do not connect the plug to a mains socket under any circumstances as there is a danger of electric shock.
CIRCUITS
Your microwave oven should be operated on a separate circuit from other appliances. Failure to do this may cause the circuit breaker to trip, the fuse to blow, or the food to cook more slowly.
ENGLISH
•As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings indentifying the terminals in your plug, proceed as follows.
•Connect the
• Connect the blue wire to the terminal marked with the letter N or coloured black.
Consult a qualified electrician or service technician if in doubt about any of these instructions.
The manufacturer of this oven will not accept any liability for damage to persons or material for non observance of these requirements.
There are no user+serviceable parts inside the oven and if the mains lead of this appliance is damaged, it must only be replaced by qualified service personnel approved by the manufacturer because special tools are required.
7
Installation & Wiring instructions
IMPORTANT NOTE :
The mains lead on this equipment is supplied with a mouldedplug incorporating a fuse.
The value of the fuse is indicated on the pin face of the plug and, if it requires replacing, a fuse approved to BS1363 of the same rating must be used. Never use the plug with the fuse cover omitted if the cover is detachable. If a replacement fuse cover is required, it must be of the same colour as the pin face of the plug.
Replacement covers are available from your Dealer. If the fitted plug is not suitable for the power points in your house or the cable is not long enough to reach a power point, you should obtain a suitable safety approved extension lead or consult your Dealer for assistance. However, if there is no alternative to cutting off the plug, remove the fuse and then safely dispose of the plug. Do not connect the plug to a mains socket, as there is a risk of shock hazard from the bared flexible cord.
|
| ||
|
| ||
|
|
|
|