Samsung DMS400TUB/XEO troubleshooting _27

PROBLEM	POSSIBLE CAUSE	SOLUTION
Leaves an oily film on the	The amount of detergent is incorrect.	Supply the appropriate amount of
dishes. The dishes are		automatic dishwasher detergent.
not clean enough.
	Too many dishes have been loaded.	Load only an appropriate number of
		dishes.
			05
	Dishes are loaded incorrectly.	Load your dishes as recommended
				troubleshooting
		(refer to the “Loading the top and
		bottom baskets” section).
	The pressure of the supplied water is	The proper pressure of the supplied
	insufficient.	water is 0.05 ~ 0.8 MPa.
	Improper detergent is being used.	Use an automatic dishwasher
		detergent.
	There is no rinse aid.	Check the dispenser and add rinse
		aid.
	The water is too hard.	Add salt into the salt container.
Is too noisy.	Sound is generated when the	This is a normal operation.
	dispenser cover is open. Sound is
	generated when the drain pump is
	operating at an early stage.
	The dishwasher is not level.	Ensure that the dishwasher is level.
	There is a ‘chopping’ sound because	Rearrange the dishes.
	a nozzle is bumping against the
	dishes.
Leaves glasses with a	The supplied water is soft and too	Underload the dishwasher and use a
dim polish.	much detergent is being supplied.	rinse aid to minimize this.
Leaves black or gray	Aluminum dishes have been loaded.	Remove the marks on the dishes
marks on the dishes.		using a low sensitivity cleaner.
Leaves a yellow or brown	This occurs from coffee and tea	Remove the soils using a spot
film on the inside of the	soils.	cleaner.
dishwasher.
Does not have any lamps	The power is not connected.	Connect the power cord.
lit.
Does not have a	The nozzle hole is clogged with food	Clean the nozzle hole.
smoothly rotating spray	particles.
arm.
Has a bent top basket	The dishes are not loaded properly.	Load your dishes as recommended
after loading dishes.		(refer to the “Loading the top and
		bottom baskets” section).

troubleshooting _27

UserManual-DMS400TU_GB.indd 27 2010-06-13 �� 9:33:48