Installing the Speakers on the Tallboy Stand
Connections 02
*
*
1.Turn the Stand Base
1
Stand
Base
2.Insert small screws (4*20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.
!CAUTION : When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screw- driver- below 15 kg.f.cm)
3.Connect the upper Speaker to the assembled Stand.
2
3
Stand
Speaker
4.Insert another large screw (5*15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.
Stand
4
5. This is the appearance after the speaker is installed. Follow this steps | 5 |
|
|
|
|
to install other speaker. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
English 17